MICROSPACE PC/104 LAN-Ethernet Module MSME104R Features LAN-Ethernet IEEE 803.2 10BASE-2 and 10BASE-T Connectors LAN Boot BIOS socket 64k buffer RAM Supports ODIS, Novell, NDIS, UNIX, NT3.5 Supports 8- or 16-bit PC/104 Onboard -9V generation Supports custom BIOS Low power consumption Single 5 Volt supply Description The MSME104 board integrates a fully Ethernet compatible LAN-Controller on a PC/104 board. The board operates on a wide temperature range of -25ºC to +70ºC. A setup program controls the I/O address section and the IRQ number. The board consists of an Ethernet IEEE802.3 network interface with 10BASE-2 and 10BASE-T connections. Selections are performed by setting jumpers or by using software tools supplied with the Ethernet tool disk. A variety of drivers is available. Ordering Information Item codes MSME104-12-R Part # 806018 Description LAN Ethernet 10BASE-T & 10BASE-2 MSME104R Technical Specifications Features General Functions LAN-Controller Memory SMC91C94 64 kBytes LAN I/O Address IRQ Ethernet IEEE802.3 Software selectable 300 - 3F0 5, 9, 10, 11 selectable LAN Custom BIOS Driver 10BASE-2 & 10BASE-T Down loadable into Flash BIOS ODI, UNIX, NDIS, NT3.5, Novell Power Supply - 9V +5VDC, 250mA generated on-board Dimensions Bus Operating Temperature Storage Temperature 3.8 x 3.6 x 0.8 (96x90x20mm) PC/104 -13ºF to +158ºF (-25ºC to +70ºC) -85ºF to +257ºF (-65ºC to +125ºC) Manufacturer USA Distributor & Support Center DIGITAL-LOGIC AG Nordstrasse 4/F CH-4708 Luterbach Switzerland Advanced Digital Logic, Inc. 4411 Morena Blvd., Suite 230 San Diego, CA 92117-4328 P: 858.490.0597 F: 858.490.0599 Email: [email protected] http://www.adlogic-pc104.com Interfaces I/O Ports Electrical Environment Remarks 104 stack through Representative msme104 rev11/01