11mm x 1.4mm BACKLIGHT AA1114/2EC/CC HIGH EFFICIENCY RED Description Features LOW POWER CONSUMPTION. The High Efficiency Red source color devices are IDEAL FOR BACKLIGHTING. made with Gallium Arsenide Phosphide on Gallium RoHS COMPLIANT. Phosphide Orange Light Emitting Diode. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAB2771 REV NO: V.3 DATE: MAR/05/2005 PAGE: 1 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1201001181 Selection Guide Part No. Dice AA1114/2EC/CC Iv (mcd) @ 20mA Lens Type HIGH EFFICIENCY RED (GaAsP/GaP) Viewing Angle Min. Typ. 2θ θ1/2 4 9 120° WATER CLEAR Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength High Efficiency Red λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 627 nm IF=20mA High Efficiency Red 625 nm IF=20mA Spectral Line Half-width High Efficiency Red 45 nm IF=20mA C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz VF Forward Voltage High Efficiency Red 2.0 2.5 V IF=20mA IR Reverse Current High Efficiency Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter High Efficiency Red Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAB2771 REV NO: V.3 DATE: MAR/05/2005 PAGE: 2 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1201001181 High Efficiency Red AA1114/2EC/CC Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength) , the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAB2771 REV NO: V.3 DATE: MAR/05/2005 PAGE: 3 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1201001181