1.1x3.4mm RECTANGULAR SOLID LAMP WP1002ID Features HIGH EFFICIENCY RED Description LOW POWER CONSUMPTION. The High Efficiency Red source color devices are RELIABLE AND RUGGED. made with Gallium Arsenide Phosphide on Gallium EXCELLENT UNIFORMITY OF LIGHT OUTPUT. Phosphide Orange Light Emitting Diode. SUITABLE FOR LEVEL INDICATOR. LONG LIFE-SOLID STATE RELIABILITY. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAF2557 REV NO: V.1 DATE: APR/16/2005 PAGE: 1 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101000277 Selection Guide Part No. Dice WP1002ID Iv (mcd) @ 10mA Lens Type HIGH EFFICIENCY RED (GaAsP/GaP) Viewing Angle Min. Typ. 2 θ 1/2 1 3 110° RED DIFFUSED Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength High Efficiency Red λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 627 nm IF=20mA High Efficiency Red 625 nm IF=20mA Spectral Line Half-width High Efficiency Red 45 nm IF=20mA C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz VF Forward Voltage High Efficiency Red 2.0 2.5 V IF=20mA IR Reverse Current High Efficiency Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter High Efficiency Red Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAF2557 REV NO: V.1 DATE: APR/16/2005 PAGE: 2 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101000277 High Efficiency Red WP1002ID Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF2557 REV NO: V.1 DATE: APR/16/2005 PAGE: 3 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101000277