4.5x2mm SMD CHIP LED LAMP APD2520EC03 Features HIGH EFFICIENCY RED Description 4.5x2mm SMT LED,0.5mm THICKNESS LOW POWER CONSUMPTION. The High Efficiency Red source color devices are made with Gallium Arsenide Phosphide on Gallium Phosphide IDEAL FOR BACKLIGHT AND INDICATOR. Orange Light Emitting Diode. VARIOUS COLORS AND LENS TYPES AVAILABLE. PACKAGE : 1000PCS/REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.2(0.008") unless otherwise noted. 3.Specifications are subject to change without notice. SPEC NO: DSAA6582 REV NO: V.5 DATE: MAR/15/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203001019 Selection Guide Part No. Dice APD2520EC03 Iv (mcd) @ 20 mA Lens Type HIGH EFFICIENCY RED (GaAsP/GaP) WATER CLEAR Viewing Angle Min. Typ. 2θ θ1/2 10 60 20° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength High Efficiency Red λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 627 nm IF=20mA High Efficiency Red 625 nm IF=20mA Spectral Line Half-width High Efficiency Red 45 nm IF=20mA C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz VF Forward Voltage High Efficiency Red 2.0 2.5 V IF=20mA IR Reverse Current High Efficiency Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter High Efficiency Red Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Reverse Voltage Operating / Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAA6582 REV NO: V.5 DATE: MAR/15/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203001019 High Efficiency Red APD2520EC03 SPEC NO: DSAA6582 REV NO: V.5 DATE: MAR/15/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203001019 APD2520EC03 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAA6582 REV NO: V.5 DATE: MAR/15/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1203001019