3x2.4mm SMD CHIP LED LAMP AP23EC/F-F01 HIGH EFFICIENCY RED Features Description zLOW POWER CONSUMPTION. The High Efficiency Red source color devices are zIDEAL FOR BACKLIGHT AND INDICATOR. Phosphide Orange Light Emitting Diode. z3mmx2.4mm SMT LED, 1.05mm THICKNESS. zWIDE VIEWING ANGLE. made with Gallium Arsenide Phosphide on Gallium zVARIOUS COLORS AND LENS TYPES AVAILABLE. zPACKAGE : 2000PCS / REEL. zRoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.2(0.008") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAF1207 REV NO: V.1 DATE: MAR/16/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: H.Q.YUAN ERP:1203000219-01 Selection Guide Part No. Dice AP23EC/F-F01 Iv (mcd) @ 20mA Lens Type HIGH EFFICIENCY RED (GaAsP/GaP) WATER CLEAR Viewing Angle Min. Typ. 2θ1/2 7 20 120° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength High Efficiency Red λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 627 nm IF=20mA High Efficiency Red 625 nm IF=20mA Spectral Line Half-width High Efficiency Red 45 nm IF=20mA C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz VF Forward Voltage High Efficiency Red 2.0 2.5 V IF=20mA IR Reverse Current High Efficiency Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter High Efficiency Red Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Reverse Voltage -40°C To +85°C Operating / Storage Temperature Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAF1207 REV NO: V.1 DATE: MAR/16/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: H.Q.YUAN ERP:1203000219-01 High Efficiency Red AP23EC/F-F01 SPEC NO: DSAF1207 REV NO: V.1 DATE: MAR/16/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: H.Q.YUAN ERP:1203000219-01 AP23EC/F-F01 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF1207 REV NO: V.1 DATE: MAR/16/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: H.Q.YUAN ERP:1203000219-01