2.0x1.25mm SMD CHIP LED LAMP AP2012EC Features HIGH EFFICIENCY RED Description 2.0mmx1.25mm SMT LED,1.1mm THICKNESS. LOW POWER CONSUMPTION. The High Efficiency Red source color devices are made with Gallium Arsenide Phosphide on Gallium Phosphide WIDE VIEWING ANGLE. Orange Light Emitting Diode. IDEAL FOR BACKLIGHT AND INDICATOR. VARIOUS COLORS AND LENS TYPES AVAILABLE. PACKAGE : 2000PCS / REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.1(0.004") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAA4049 REV NO: V.4 DATE: MAR/18/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1203000098 Selection Guide Part No. Dice AP2012EC Iv (mcd) @ 20mA Lens Type HIGH EFFICIENCY RED (GaAsP/GaP) WATER CLEAR Viewing Angle Min. Typ. 2 θ 1/2 4 12 120° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength High Efficiency Red λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 627 nm IF=20mA High Efficiency Red 625 nm IF=20mA Spectral Line Half-width High Efficiency Red 45 nm IF=20mA C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz VF Forward Voltage High Efficiency Red 2.0 2.5 V IF=20mA IR Reverse Current High Efficiency Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter High Efficiency Red Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAA4049 REV NO: V.4 DATE: MAR/18/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1203000098 High Efficiency Red AP2012EC SPEC NO: DSAA4049 REV NO: V.4 DATE: MAR/18/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1203000098 AP2012EC Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAA4049 REV NO: V.4 DATE: MAR/18/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1203000098