2.0x1.25mm SMD CHIP LED LAMP APT2012SYC Features SUPER BRIGHT YELLOW Description 2.0mmx1.25mm SMT LED,0.75mm THICKNESS. The Super Bright Yellow device is made with DH InGaAlP LOW POWER CONSUMPTION. (on GaAs substrate) light emitting diode chip. WIDE VIEWING ANGLE. IDEAL FOR BACKLIGHT AND INDICATOR. VARIOUS COLORS AND LENS TYPES AVAILABLE. PACKAGE : 2000PCS / REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.1(0.004") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAD0948 REV NO: V.3 DATE: MAR/12/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG ERP: 1203001890 Selection Guide Part No. Dice APT2012SYC Iv (mcd) @ 20mA Lens Type SUPER BRIGHT YELLOW (InGaAIP) Viewing Angle Min. Typ. 2 θ 1/2 36 150 120° WATER CLEAR Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength Super Bright Yellow λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 590 nm IF=20mA Super Bright Yellow 588 nm IF=20mA Spectral Line Half-width Super Bright Yellow 28 nm IF=20mA C Capacitance Super Bright Yellow 25 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Yellow 2.0 2.5 V IF=20mA IR Reverse Current Super Bright Yellow 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Yellow Units Power dissipation 125 mW DC Forward Current 30 mA Peak Forward Current [1] 150 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD0948 REV NO: V.3 DATE: MAR/12/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG ERP: 1203001890 Super Bright Yellow APT2012SYC SPEC NO: DSAD0948 REV NO: V.3 DATE: MAR/12/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG ERP: 1203001890 APT2012SYC Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength), the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAD0948 REV NO: V.3 DATE: MAR/12/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG ERP: 1203001890