SURFACE MOUNT DISPLAY Part Number: KCPSA04-103 Features YELLOW Description 0.4 INCH CHARACTER HEIGHT. The Yellow source color devices are made with Gallium LOW CURRENT OPERATION. Arsenide Phosphide on Gallium Phosphide Yellow Light HIGH CONTRAST AND LIGHT OUTPUT. Emitting Diode. EASY MOUNTING ON P.C. BOARDS OR SOCKETS. CATEGORIZED FOR LUMINOUS INTENSITY. MECHANICALLY RUGGED. GRAY FACE,WHITE SEGMENT. PACKAGE : 400PCS / REEL. MOISTURE SENSITIVITY LEVEL : LEVEL 4. RoHS COMPLIANT. Package Dimensions & Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. 3.The gap between the reflector and PCB shall not exceed 0.25mm SPEC NO: DSAG4714 REV NO: V.1 DATE: MAY/20/2006 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: W.J.ZHU PAGE: 1 OF 4 Selection Guide Part No. Dice KCPSA04-103 Iv (ucd) [1] @ 10mA Lens Type YELLOW (GaAsP/GaP) WHITE DIFFUSED Description Min. Typ. 800 3400 Common Anode, Rt. Hand Decimal. Note: 1. Luminous Intensity / Luminous Flux: +/-15%. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Yellow λD [1] Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 590 nm IF=20mA Yellow 588 nm IF=20mA Spectral Line Half-width Yellow 35 nm IF=20mA C Capacitance Yellow 20 pF VF=0V;f=1MHz VF [2] Forward Voltage Yellow 2.1 2.5 V IF=20mA IR Reverse Current Yellow 10 uA VR = 5V Notes: 1. Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. Absolute Maximum Ratings at TA=25°C Parameter Yellow Units Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current [1] 140 mA 5 V Reverse Voltage Operating / Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAG4714 REV NO: V.1 DATE: MAY/20/2006 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: W.J.ZHU PAGE: 2 OF 4 Yellow KCPSA04-103 SPEC NO: DSAG4714 REV NO: V.1 DATE: MAY/20/2006 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: W.J.ZHU PAGE: 3 OF 4 KCPSA04-103 Recommended Soldering Pattern (Units : mm; Tolerance: ±0.15) Tape Specifications (Units : mm) SPEC NO: DSAG4714 REV NO: V.1 DATE: MAY/20/2006 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: W.J.ZHU PAGE: 4 OF 4