18mm (0.7 INCH) SINGLE COLOR DOT MATRIX DISPLAY ATTENTION OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DISCHARGE SENSITIVE DEVICES Features z0.7 zLOW The Blue source color devices are made with SIZE 2mm. zEASY Static electricity and surge damage the LEDS. WITH ASCII AND EBCDIC CODES. VERTICALLY AND HORIZONTALLY. MOUNTING ON P.C. BOARDS OR SOCKETS. zMECHANICALLY zSTANDARD: z RoHS InGaN on SiC Light Emitting Diode. CURRENT OPERATION. zCOMPATIBLE zSTACKABLE BLUE Description INCH MATRIX HEIGHT. zDOT TC07-11PBWA RUGGED. It is recommended to use a wrist band or anti-electrostatic glove when handling the LEDs. All devices, equipment and machinery must be electrically grounded. GRAY FACE, WHITE DOT. COMPLIANT. Package Dimensions & Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. SPEC NO: DSAC2563 APPROVED: J. Lu REV NO: V.4 CHECKED: Joe Lee DATE: MAY/21/2005 DRAWN: H.Q.YUAN PAGE: 1 OF 3 Selection Guide Part No. Dice TC07-11PBWA Iv (ucd) @ 10mA Lens Type BLUE (InGaN) WHITE DIFFUSED Min. Typ. 4700 13200 Description Column Cathode Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Blue λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 468 nm IF=20mA Blue 470 nm IF=20mA Spectral Line Half-width Blue 25 nm IF=20mA C Capacitance Blue 65 pF VF=0V;f=1MHz VF Forward Voltage Blue 3.65 4.2 V IF=20mA IR Reverse Current Blue 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Blue Units Power dissipation 102 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Reverse Voltage Operating / Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. SPEC NO: DSAC2563 APPROVED: J. Lu REV NO: V.4 CHECKED: Joe Lee DATE: MAY/21/2005 DRAWN: H.Q.YUAN PAGE: 2 OF 3 Blue TC07-11PBWA Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAC2563 APPROVED: J. Lu REV NO: V.4 CHECKED: Joe Lee DATE: MAY/21/2005 DRAWN: H.Q.YUAN PAGE: 3 OF 3