2.4mm FLAT TOP LED LAMP WP443EDT ORANGE Description Features The Orange source color devices are made with Gallium LOW POWER CONSUMPTION. Arsenide Phosphide on Gallium Phosphide Orange Light I.C.COMPTATIBLE. LONG LIFE - SOLID STATE RELIABILITY. Emitting Diode. FITS 2.4mm HOLE IN PANEL UP TO 4mm THICK. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAE9390 REV NO: V.2 DATE: APR/18/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP: 1101011655 Selection Guide Part No. Dice WP443EDT Iv (mcd) @ 10mA Lens Type ORANGE (GaAsP/GaP) ORANGE DIFFUSED Viewing Angle Min. Typ. 2θ θ1/2 3 10 100° Units Test Conditions Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. Max. λpeak Peak Wavelength Orange 627 nm IF=20mA λD Dominant Wavelength Orange 625 nm IF=20mA ∆λ1/2 Spectral Line Half-width Orange 45 nm IF=20mA C Capacitance Orange 15 pF VF=0V;f=1MHz VF Forward Voltage Orange 2.0 2.5 V IF=20mA IR Reverse Current Orange 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Orange Units 105 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Power dissipation Reverse Voltage Operating/Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAE9390 REV NO: V.2 DATE: APR/18/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP: 1101011655 Orange WP443EDT SPEC NO: DSAE9390 REV NO: V.2 DATE: APR/18/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP: 1101011655 PACKING & LABEL SPECIFICATIONS WP443EDT Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAE9390 REV NO: V.2 DATE: APR/18/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP: 1101011655