T-1 (3mm) SOLID STATE LAMP WP7104SYC SUPER BRIGHT YELLOW Features Description zPOPULAR T-1 DIAMETER PACKAGE. The Super Bright Yellow device is made with DH zLOW POWER CONSUMPTION. zGENERAL PURPOSE LEADS. InGaAlP (on GaAs substrate) light emitting diode chip. zRELIABLE AND RUGGED. zLONG LIFE - SOLID STATE RELIABILITY. zAVAILABLE ON TAPE AND REEL. z RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAE7752 REV NO: V.2 DATE: APR/18/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN EPR:1101008457 Selection Guide Part No. Dice WP7104SYC Iv (mcd) @ 20mA Lens Type SUPER BRIGHT YELLOW (InGaAlP) WATER CLEAR Viewing Angle Min. Typ. 2θ1/2 280 700 34° Units Test Conditions Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. Max. λpeak Peak Wavelength Super Bright Yellow 590 nm IF=20mA λD Dominant Wavelength Super Bright Yellow 588 nm IF=20mA ∆λ1/2 Spectral Line Half-width Super Bright Yellow 28 nm IF=20mA C Capacitance Super Bright Yellow 25 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Yellow 2.0 2.5 V IF=20mA IR Reverse Current Super Bright Yellow 10 uA VR= 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Yellow Units Power dissipation 125 mW DC Forward Current 30 mA Peak Forward Current [1] 150 mA Reverse Voltage 5 V Operating / Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAE7752 REV NO: V.2 DATE: APR/18/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN EPR:1101008457 Super Bright Yellow WP7104SYC SPEC NO: DSAE7752 REV NO: V.2 DATE: APR/18/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN EPR:1101008457 PACKING & LABEL SPECIFICATIONS WP7104SYC Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAE7752 REV NO: V.2 DATE: APR/18/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN EPR:1101008457