KWL-3232Ux SERIES Light Bar Display DESCRIPTION: PACKAGE DIMENSIONS The KWL-3232Ux series is 32.00mm x 32.00mm square type light bar display designed for a variety of applications where a large source of light is required, such as panel indicators, backlight legends and light arrays. 32.00(1.260) 30.00(1.181) 30.00(1.181) 32.00(1.260) PIN 1 + o ABSOLUTE MAXIMUM RATINGS: (Ta=25 C) Parameter Max Reverse Voltage per segment 5V Reverse Current per segment (Vr = 5V) 100µA Derating Linear from 25oC per segment 0.4mA/ oC Operating Temperature Range -40oC To 85oC Storage Temperature Range -40oC To 100oC Soldering Temperature 1.6mm(1/16") from body for 5 sec. at 260oC 11.0(0.433) φ0.50(0.020) 6.00(.236) 5.08(0.2) NOTES : 1. All dimensions are in millimeters (inches). 2. Tolerance is +0.25mm(0.010) unless otherwise specified. 3. Specifications are subject to change without notice. 4. NP: No Pin. 5. NC: No Connect. INTERNAL CIRCUIT DIAGRAM 1 TESTING CONDITION FOR EACH PARAMETER : Parameter Forward Voltage Peak Emission Wave Length Spectral Line Half-Width Reverse Current Average Luminous Intensity Symbol Vf λρ ∆λ Ir Iv Unit V nm nm µA µ cd Test Condition If=20mA If=20mA If=20mA Vr=5V If=10mA 2 o PART NO. SELECTION AND APPLICATION INFORMATION (RATINGS AT 25 C AMBIENT) Chip Part No. Wave C.C or C.A Absolute Maximum Ratings Electro-optical Characteristic ∆λ Pd If 635 45 100 50 100 1.7 1.9 2.6 10-20 6.0 16.0 660 20 100 50 100 1.5 1.9 2.6 10-20 15.0 32.0 565 30 100 50 100 1.7 2.2 2.6 10-20 6.0 14.0 Super Green 570 30 100 50 100 1.7 2.2 2.6 10-20 10.0 20.0 Yellow 585 30 100 50 100 1.7 1.9 2.6 10-20 14.0 Raw Material Emitted Color KWL-3232U3 GaAsP/GaP Hi-Eff Red KWL-3232US GaAlAs Super Red KWL-3232U2 GaP Green KWL-3232UG GaP KWL-3232U6 GaAsP/GaP Common Anode Length λρ (nm) If If Vf (V) Iv (mcd) (Peak) (Rec) Per Chip (nm) (mW) (mA) (mA) Min. Typ. Max. mA Min. Typ. 6.0 REMARKS : 1. The average luminous intensity is obtained by summing the luminous intensity of each segment and dividing by the total number of segments. 2. Luminous intensity is measured with a light sensor and filter combination that approximates the CIE (International Commission on Illumination) eye-response curve. 3. Clean only by pure water, isopropanol, ethanol, Freon TF (or equivalent).