NSC SC14408B80VD

SC14408
Complete Baseband Processor for DECT Handsets
General Description
■ Embedded 16 bit CompactRISCTM Micro Controller.
(CR16B) with programmable clock speeds.
■ 384 kbyte Flash.
■ ACCESSBUSTM or MICROWIRETM interfaces
■ 6 kilobyte on-chip Data Memory.
■ One full duplex ADPCM transcoder.
■ On-chip 14-bit linear CODEC.
■ 14 upto 44 dB gain differential microphone input buffer.
■ 80 Ω loudspeaker driver.
■ Software controlled gain on audio input and output.
■ Peak hold ADC for RSSI measurement.
■ Five general purpose inputs can be multiplexed on an
8 bit ADC with selectable ranges.
■ On-chip dedicated TDMA instruction co-processor
which supports DECT and ISM-bands providing 1.152
Mb/s, 1.024 Mb/s, 0.576 Mb/s, 0.512 Mb/s, 0.288 Mb/s
and 0.256 Mb/s.
■ Seven programmable control signals for radio front
end.
■ Full and double slot, protected and unprotected Bfields.
■ Duplex quality handsfree operation.
■ Tone generator. Tones consisting of 3 frequencies can
be programmed
■ Linear PCM interface for external codec.
■ ISM band support with 8/9 x 10.368 Mc xtal = 9.216 Mc
■ On chip LCD controller (6X30 segments)
The SC14408 is a CMOS chip optimized to handle all the
audio, signal and data processing needed within a DECT
(1.9GHz) or in the 2.4GHz ISM digital band handset. An
ADPCM transcoder, a very low power CODEC and Analog Frontend is integrated. Direct connections towards microphone and a (dynamical) loudspeaker are provided.
Duplex quality handsfree operation is integrated.
The SC14408 is designed to fit to any radio design.
A dedicated TDMA controller handles all physical layer
slot formats and radio control.
National Semiconductors standard CompactRISCTM
CR16B 16 bit microcontroller takes care of all the higher
protocol stack.
Features
■ Integrated DECT Baseband transceiver optimized for
GAP handsets according to ETS 300 175-2, 175-3 &
175-8.
■ Two on board low drop voltage regulators with 2.5V and
3.0- 3.8V (with external resistors the voltage can be determined) output.
■ 2V upto 3.6V battery input with onboard step up converter.
■ Advanced battery management unit
■ Very low power in active and paging mode.
Note: ACCESSBUSTM, MICROWIRETM and CompactRISCTM are trademarks of National Semiconductor Corporation.
________________________________________________________________________________________________
System Diagram
© 2001 National Semiconductor Corporation
1
www.national.com
SC14408
May 2001
V 1.0
SDA2
SCL2
RSTN
VSS
VDD
VREF+
MIC+
AGND
MICVREFVREF_HS
LRSLRS+
LRS_HS
AVD2
AVS2
VBUF
VBAT1
VBAT2 / DC_DIS
LDO2_CTRL
80
79
78
77
76
75
74
73
72
71
70
69
68
67
66
65
64
63
62
61
PD7/P3[7]
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
SC14406BxxVV
SC14406BxxVD
SC14408B80VV
SC14408B80VD
60
59
58
57
56
55
54
53
52
51
50
49
48
47
46
45
44
43
42
41
LDO1_CTRL
LDO1_sense
ADC3 (battery current)
AVS_sense
DC_I
DC_Sense
DC_stab
VBAT3
P2[7] / DC_CTRL
stop_charge/P2[6]
P2[5] / SDA1
P2[4] / SCL1
P2[3] / PCM_D0 / ADC1
P2[2] / ADC0
P2[1] / PCM_DI / PWM1
VDD
VSS
P2[0] / PWM0
P1[7] / CHARGE
P1[6] / PON
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
PD1/P3[1]
PD5/P3[5]
PD4/P3[4]
PD3/P3[3]
PD2/P3[2]
VDD
VSS
RFCLK
VDDRF
VSSRF
Xtal1
CAP
AVS
AVD
RSSI
RDI
CMPREF
TDO
LE
SO
SK
PCM_CLK / DAC2 / ADC2
PCM_FSC / PD6 /
UTX / P0[0]
URX / P0[1]
P0[2]
P0[3]
P0[4]
P0[5]
P0[6]
P0[7]
VDD
VSS
INT0n / P1[0]
INT1n / P1[1]
INT2n / P1[2]
INT3n / P1[3]
INT4n / P1[4]
EEROM/INT5n / P1[5]
SC14408
1.0 Pin type definitions
,
2
14-03-2001
www.national.com
SC14408
P1[7..0]
PWM
P0[7..0]
CR16B
UART
ACCESS
BUS1
ACCESS
BUS2
XTAL
TRIMMING
CompactRISC
16 bit micro controller
DMA
sclk
16 bits
System Bus
Interface
8 bits
4 KBYTE
ICU
384kbyte
FLASH
CLOCK
DIVIDER
BOOT
ROM
TIMERS
8 BIT
ADC
DATA
RAM
LCD
DRIVER
temperature
sensor
P2[7..0]
DSP
1 KBYTE
MICRO CODE
RAM
RAM
10
100X
2 KBYTE
SHARED
DC/DC convertor
RAM
Battery&charge
control
2X Voltage
regulator
DEDICATED INSTRUCTION
PROCESSOR
CODEC
HANDS
FREE
DSP
RF
ENCRYP
ADPCM
TION
BMC
CONTROL
PINS
CLOCK
RECOVERY
3 BITS
FIR FILTER
AFE
MICRO
WIRE
8 BIT DAC
GAUSSIAN
SHAPER
RF INTERFACE
80Ω
HEADSET
FIGURE 1. SC14408 Block diagram
3
www.national.com
SC14408
2.0 Package information
FIGURE 2. 80 pins Quad Flat Pack. NS Package: vje80a
,
4
www.national.com
National Semiconductor B.V reserves the right to make changes without notice to any products herein to improve reliability, function
or design. National does not assume any liability arising out of the application or use of any product or circuit described herein; neither
does it convey any license under its patent rights, nor the right of others.
________________________________________________________________________________________________
LIFE SUPPORT POLICY
NATIONAL’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES
OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT AND GENERAL COUNSIL OF
NATIONAL SEMICONDUCTOR CORPORATION. As used herein:
2. A critical component is any component of a life support device
or system whose failure to perform can be reasonably expected
to cause the failure of the life support device or system, or to
affect its safety or effectiveness.
1. Life support devices or systems are devices or systems which,
(a) are intended for surgical implant into the body, or (b) support or sustain life, and whose failure to perform, when properly used in accordance with instructions for use provided in
the labeling, can be reasonably expected to result in a significant injury to the user.
National Semiconductor
Corporation
Tel: 1-800-272-9959
Fax: 1-800-737-7018
Email: [email protected]
National Semiconductor
Europe
Fax:
(+49) 0-180-530 85 86
Email:
[email protected]
Deutsch Tel:
(+49) 0-180-530 85 85
English Tel:
(+49) 0-180-532 78 32
National Semiconductor
Asia Pacific
Customer Response Group
Tel: 65-254-4466
Fax: 65-250-4466
Email: [email protected]
National Semiconductor
Japan Ltd.
Tel: 81-3-5620-6175
Fax: 81-3-5620-6179
National does not assume any responsibility for use of any circuitry described, no patent licences are implied and National reserves the right at any time without notice to
change said circuitry and specifications
5
www.national.com
SC14408
3.0 Product status definitions