+++ Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: [email protected] Web: http://www.frontierusa.com 1A ULTRA FAST EFFICIENT RECTIFIER MUR105-LFR THRU MUR1100-LFR FEATURES z LOW POWER LOSS, HIGH EFFICIENCY z LOW LEAKAGE z LOW FORWARD VOLTAGE DROP z HIGH CURRENT CAPABILITY z HIGH SPEED SWITCHING z HIGH RELIABILITY z HIGH CURRENT SURGE z GLASS PASSIVATED CHIP JUNCTION z ROHS 1.0(25.4) MIN .034(0.9) .028(0.7) .205(5.2) .166(4.2) .107(2.7) .080(2.0) MECHANICAL DATA z CASE: MOLDED PLASTIC, DO41, DIMENSIONS IN INCHES AND (MILLIMETERS) z EPOXY: UL 94V-0 RATE FLAME RETARDANT z LEAD: MIL-STD-202E METHOD 208C GUARANTEED z MOUNTING POSITION: ANY z WEIGHT: 0.34 GRAMS 1.0(25.4) MIN MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS RATINGS AT 25°C AMBIENT TEMPERATURE UNLESS OTHERWISE SPECIFIED SINGLE PHASE, HALF WAVE, 60 HZ, RESISTIVE OR INDUCTIVE LOAD. FOR CAPACITIVE LOAD, DERATE CURRENT BY 20% MUR MUR MUR MUR MUR MUR MUR MUR RATINGS SYMBOL 105-LF 110-LF 115-LF 120-LF 140-LF 160-LF 180-LF 1100-LF UNITS R R R R R R R R MAXIMUM RECURRENT PEAK REVERSE VOLTAGE VRRM 50 100 150 200 400 600 800 1000 V MAXIMUM RMS VOLTAGE VRMS 35 70 105 140 280 480 560 700 V MAXIMUM DC BLOCKING VOLTAGE VDC 50 100 150 200 400 600 800 1000 V MAXIMUM AVERAGE FORWARD RECTIFIED CURRENT IO 1.0 A 0.375” (9.5mm) LEAD LENGTH AT TA=55°C PEAK FORWARD SURGE CURRENT, 8.3ms SINGLE HALF IFSM 35 A SINE-WAVE SUPERIMPOSED ON RATED LOAD TYPICAL JUNCTION CAPACITANCE (NOTE 1) CJ 70 PF TYPICAL THERMAL RESISTANCE (NOTE 2) Rθja 50 ℃/W STORAGE TEMPERATURE RANGE TSTG - 55 TO + 150 ℃ OPERATING TEMPERATURE RANGE TOP - 55 TO + 150 ℃ ELECTRICAL CHARACTERISTICS (AT TA =25°C UNLESS OTHERWISE NOTED) MUR MUR MUR MUR MUR MUR MUR MUR CHARACTERISTICS SYMBOL 105-LF 110-LF 115-LF 120-LF 140-LF 160-LF 180-LF 1100-LF UNITS R R R R R R R R MAXIMUM FORWARD VOLTAGE AT IO DC VF 0.875 1.25 1.75 V MAXIMUM REVERSE CURRENT AT 25℃ IR MAXIMUM REVERSE CURRENT AT 100℃ IR 2 MAXIMUM REVERSE RECOVERY TIME (NOTE 3) TRR 25 NOTE: 1. MEASURED AT 1 MHZ AND APPLIED REVERSE VOLTAGE 0F 4.0 VOLTS 2. BOTH LEADS ATTACHED TO HEAT SINK 20x20x1t(mm) COPPER PLATE AT LEAD LENGTH 5mm 3. REVERSE RECOVERY TEST CONDITIONS: IF=0.5A, IR=1.0A, IRR=0.25A MUR105-LFR THRU MUR1100-LFR μA 5 μA 50 50 75 Page: 1 nS RATINGS AND CHARACTERISTIC CURVE MUR105-LFR THRU MUR1100-LFR FIG. 1-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC CURRENT DERATING CURVE Trr 100Ω NO INDUCTIVE +0.5A (-) D.U.T. PULSE GENERATOR ( NOTE 2 ) (+) 25 Vdc (approx) 1Ω NON INDUCTIVE (-) 0 -0.25A OSCILLOSCOPE ( NOTE 1 ) (+) CURRENT (A) 2.0 AVERAGE FORWARD 50Ω NO INDUCTIVE FIG. 2-TYPICAL FORWARD 1.0 0 25 50 75 100 125 150 175 AMBIENT TEMPERATURE (oC) 1cm NOTE: 1. RISE TIME=7ns MAX. INPUT IMPEDANCE=1 MOhms 22PF 2. RISE TIME =10ns MAX. SOURCE IMPEDANCE=50 OHMS SET TIME BASE FOR 10/20 ns/cm FIG. 4-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS 10 INSTANTANEOUS FORWARD CURRENT (A) INSTANTANEOUS REVERSE CURRENT (uA) FIG. 3-TYPICAL REVERSE CHARACTERISTICS 100 1000 Single Phase Half Wave 60 Hz Resistive or Inductive Load TJ=125oC 10 100 o TJ=80 C 1.0 10 TJ=25oC 1.0 0.1 0.1 0.01 0.01 20 40 60 80 MUR105-LF ~120-LF 1.0 .1 MUR140-LF ~1100-LF .01 .001 .2 100 120 140 .4 .6 .8 1.0 1.2 1.4 1.6 1.8 INSTANTANEOUS FORWARD VOLTAGE (V) PERCENT OF RATED PEAK REVERSE VOLTAGE (%) FIG. 5-MAXIMUM NON-REPETITIVE FIG. 6-TYPICAL JUNCTION CAPACITANCE FORWARD SURGE CURRENT 200 100 8.3 ms Single Half Sine Wave (JEDEC Method) 30 JUNCTION CAPACITANCE (pF) PEAK FORWARD SURGE CURRENT (A) 40 25 20 15 10 5 0 40 TJ=25oC 20 10 6 4 2 1 1 5 10 20 50 100 NUMBER OF CYCLES AT 60 Hz MUR105-LFR THRU MUR1100-LFR .1 .2 .4 1.0 2 4 10 20 40 100 REVERSE VOLTAGE (V) Page: 2