HITRON HAC203P

H HiTRON
UNIVERSAL AC INPUT HARMONIC CORRECTION
AC-DC HOT-SWAP LOW VOLTAGE CompactPCI
PENTA OUTPUT 200 WATTS ACTIVE CURRENT SHARING
SWITCHING POWER SUPPLIES HAC203P SERIES
FEATURES:
200W 3U X 9HP EUROCARD PACKAGE
MEET IEC 61000-3-2 HARMONIC
CORRECTION
INTERNAL OR-ING DIODES FOR
N+1 REDUNDANCY
HOT-SWAPPABLE
THIRD-WIRE CURRENT SHARING
EMI MEET EN 55022 / FCC CLASS A
CE MARKING COMPLIANCE
FULLY COMPLIANT WITH PICMG
SPECIFICATION
INPUT SPECIFICATION
OUTPUT SPECIFICATION
Input Voltage: Typ. 90-264Vac.
Power Factor Correction: Meet Harmonic Correction
IEC 61000-3-2.Power Factor typ. 0.97-0.98.
Input Connector: Positronic 47-pin PCIH47M400A1.
Input Frequency: 47-63Hz.
Inrush Current: 8.66Arms @ 230Vac.
Input Current: 2.5A @115Vac/1.18A @230Vac.
Dielectric Withstand: Meet IEC 60950-1 regulation.
EMI: Meet EN 55022 / FCC Class A.
Hold-up Time: 18.4mS @115Vac, 20.8mS @230Vac.
Earth Leakage: Less than 0.64mA @230Vac.
Remote ON/OFF: Available at [INH#] & [EN#] pins.
Status LED: <Green> means valid input voltage.
<Amber> means a critical fault.
Thermal Protection (OTP): Installed NTC and thermostat for
thermal sensor at [DEG#] pin.
Output Voltage: See Ratings Chart.
Output Current: See Ratings Chart.
Output Wattage: Typ. 200W continuous.
Output Connector: Positronic 47-pin PCIH47M400A1.
Line Regulation: Typ. 0.2%.
Load Regulation: Typ. ±1%.
Noise & Ripple: Typ. 1% peak to peak or 55mV,
whichever is greater.
OVP: Built-in at all outputs.
Adjustability: Available at VO1,2,3 & 4.
Remote Sensing: Available at VO1,VO2,VO3 & VO4.
Hot-Swap: Available.
N+1 Redundancy: Installed with internal OR-ing diodes
at all outputs for N+1 redundancy operation.
Current Sharing: Third-wire current sharing at VO1,2,3 & 4.
Over Current Protection (OCP): Installed at each rail.
DC OK: Available at VO1,2,3,4 & 5.
Overload Protection (OLP): Fully protected against output
overload or short circuit. Typical 120-150% max. load.
Consult the factory for special OLP setting.
GENERAL SPECIFICATION
Efficiency: Typ. 67-69 %.
Switching Frequency: 133K Hz.
Circuit Topology: Forward circuit.
Transient Response: Peak transient less than 50mV and
recovers within 0.96mS after 25% load-change.
Safety Standard: IEC 60950-1 Class I.
Construction: Eurocard 3U X 9HP X 185mm
CompactPCI format.
Operating Temperature: -5 to +50 °C at full load with
specified air flow. Derates linearly to 50% at +60 °C.
Storage Temperature: -40 to +85 °C.
Temperature Coefficient: Typ. ±0.02% / °C.
Cooling: At least 14CFM moving air is required to achieve
full rating power 200W in a confined area.
Power Density: 2.85 Watts/ Cubic Inch.
Note: Due to requests in market and advances in technology, specifications subject to change without notification.
In application
-3-
OUTPUT VOLTAGE / CURRENT RATINGS CHART
PENTA OUTPUT
MAIN +VO1★@#≡⊙
AUX. +VO2★@#≡⊙▲ AUX. +VO3★@#≡⊙▲ AUX. +VO4★@#≡⊙▲
AUX. VO5★⊙●◇
MODEL NO.
Min. Typ. Volt. Max. Min. Typ. Volt. Max. Min. Typ. Volt. Max. Min. Typ. Volt. Max. Min. Typ. Volt. Max.
HAC203P-P033BCEI(E)
1A
20A 3.3V 20A 0.5A 9A
5V
9A
0A
12A 2.5V 12A
0A
17A 1.5V 17A
1A
2A
12V
2A
Symbol: "★" OVP built-in. "@" Adjustable. "#" Remote sensing. "≡" 3rd-wire Load Sharing. "◇" Floating.
"⊙" Installed with Or-ing diode. "▲" Magnetic Amplifier. "●" Installed with Post Regulator.
Remark: Peak load less than 60sec. with duty cycle <10%.
Max. load is the continuous operating load of each rail. But the max. load of each rail can't be drawn from all outputs at the same time.
MECHANICAL DIMENSIONS: MM [INCHES]
WEIGHT: 666.0 g (23.5 Oz.)
INPUT & OUTPUT CONNECTORS PIN ASSIGNMENT
AC
INPUT
PENTA OUTPUT
ASSIGNMENT
L
N
G
V1
CNTR &PIN #
47
46
45
13,14,15,
16,17,18
ASSIGNMENT
EN
DEG INH
27
38
CNTR &PIN #
Mating connector: PCIH47F400A1.
39
FAL
42
V2 V3 V4
1
2
3,4
CRDEXEISIT_1
31
DC COM
5,6,7,8,9,10,
11,12,22,24
+V5 -V5
20
19
STATUS/CONTROL
CRDSLOT_ID0
EXEISIT_0
32
40
-4-
V1 V2 V3 V4
V4
V1 V2
-S
V3S
CS CS CS CS
S
S S
33
30
35
SLOT_ID1
41
37
34
28 29 25 26
I2C_SDA I2C_SCL
43
44
NC
21,23,36