GBL4005-GBL410 Silicon Bridge Rectifiers VOLTAGE RANGE: 50 --- 1000 V CURRENT: 4.0 A Features KBJ2 Ideal for printed circuit board 20± 0.55 3.5± 0.35 2.0± 0.25 plas tic technique 11± 0.25 Reliable low cos t cons truction utilizing m olded Plas tic m aterrial has U/L flam m ability clas s ification ~ ~ + - 94V-O 1.1± 0.25 2.3± 0.2 18± 0.5 1.2± 0.1 Mounting pos ition: Any Glass passivated chip junctions 0.6± 0.15 5.0± 0.3 Dimensions in millimeters MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 am bient tem perature unles s otherwis e s pecified. Single phas e,half wave,60 Hz,res is tive or inductive load. For capacitive load,derate by 20%. GBL 4005 GBL 401 GBL 402 GBL 404 GBL 406 GBL 408 GBL 410 UNITS Maximum recurrent peak reverse voltage VRRM 50 100 200 400 600 800 1000 V Maximum RMS voltage V R MS 35 70 140 280 420 560 700 V Maximum DC blocking voltage VDC 50 100 200 400 600 800 1000 V Maximum average f orw ard Tc=50 output current 4.0 IF (AV) @TJ =40 A 3.0 Peak f orw ard surge current 8.3ms single half -sine-w ave IF SM 150.0 A VF 1.0 V superimposed on rated load Maximum instantaneous f orw ard voltage at 2.0 A Maximum reverse current at rated DC blocking voltage @TA =25 @TC =100 Typical junction capacitance per leg (note 1) Typical thermal resistance per leg Operating junction temperature range Storage temperature range 5.0 IR CJ 65 25 (note 2) RθJL 34 (note 3) RθJL 15 TJ - 55 ---- + 150 TSTG - 55 ---- + 150 N OTE: 1. Measured at 1.0 MHz and applied rev erse v oltage of 4.0 volts. 2. U nits m ounted on P.C .B. with 0.5x0.5" (12x12m m) copper pads and 0.375" (9.5m m ) lead length. 3. Unit case mounted on 3.0x3.0x0.11" thick (7.5x7.5x0.3cm) AI. Plate. http://www.luguang.cn μA 500.0 mail:[email protected] pF /W GBL4005-GBL410 Silicon Bridge Rectifiers Ratings AND Charactieristic Curves FIG.2 -- TYPICAL FORWARD CHARACTERISTIC INSTANTANEOUS FORWARD CURRENT, AMPERES AVERAGE FORWARD CURRENT, AMPERES FIG.1 -- DERATING CURVE FOR OUTPUT RRECTIFIED CURRENT 4 .0 3 .0 2 .0 1 .0 0 0 50 1 00 1 50 TEMPERATURE, INSTANTANEOUS REVERSE CURRENT, MICRO AMPERES 150 TJ=TJ max. SINGLE SINE-WAVE (JEDEC METHOD) 120 90 60 30 1 1.0 CYCLE 10 10 1.0 TJ =25 Pulse Width =300uS 0.1 .01 .4 .6 .8 1 1.2 100 NUMBER OF CYCLES AT 60Hz 500 T C= 1 0 0 100 10 1.0 0.1 T J=25 .01 0 20 40 60 TJ=25 f=1.0 MHz VSIG=50mVp-p 100 40 50-400V 600-1000V 1 4 80 100 PERCENT OF RATED PEAK REVERSE VOLTAGE 1000 10 100 REVERSE VOLTAGE, VOLTS http://www.luguang.cn 1.6 INSTANTANEOUS FORWARD VOLTAGE, VOLTS FIG.5 -- TYPICAL JUNCTION CAPACITANCE PER LEG 10 .1 1.4 FIG.4 -- TYPICAL REVERSE CHARACTERISTIC DURGE CURRENT JUNCTION CAPACITANCE, pF PEAK FORWARD SURGE CURRENT, AMPERES FIG.3 -- MAXIMUM NON-REPETITIVE PEAK FORWARD 100 mail:[email protected]