GBU801-GBU807 Single Phase 8.0AMP.Glass Passivated Bridge Rectifiers GBU Features Ideal for printed circuit board Reliable low cost construction Plastic material has Underwriters Laboratory Flammability Classification 94V-0 High case dielectric strength of 1500VRMS Surge overload rating to 200 amperes peak High temperature soldering guaranteed: 260 oC / 10 seconds / .375”, (9.5mm) lead lengths. Mechanical Data Case: Molded plastic body. W eight: 0. 3 ounce, 4.3 grams Mounting torque: 5 in. lb. Max. Dimensions in inches and (millimeters) Maximum Ratings and Electrical Characteristics Rating at 25 oC ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20% Type Number Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Rectified Current @T C = 100 oC Peak Forward Surge Current, 8.3 ms Single Half Sine-wave Superimposed on Rated Load (JEDEC method ) Maximum Instantaneous Forward Voltage @ 4.0A @ 8.0A Maximum DC Reverse Current @ T A =25 oC at Rated DC Blocking Voltage @ T A =125 oC Rating for fusing I(AV) 8.0 A IFSM 200 A VF 1.0 1.1 5.0 500 166 V IR 2 ( t<8.3ms ) Typical Junction Capacitance ( Note 3 ) Typical Thermal Resistance Per Leg Symbol GBU GBU GBU GBU GBU GBU GBU Units 801 802 803 804 805 806 807 V RRM 50 100 200 400 600 800 1000 V V RMS 35 70 140 280 420 560 700 V V DC 50 100 200 400 600 800 1000 V ( Note 1 ) ( Note 2 ) Operating Temperature Range I t Cj R θJA R θJC TJ 211 uA uA 2 A sec 94 21 2.0 -55 to +150 -55 to + 150 Storage Temperature Range T STG 1. Units Mounted In Free Air No Heat Sink On PCB 0.5” x 0.5 “ (12mm x 12mm) Copper Pads, Notes 0.375” (9.5mm) Lead Length. 2. Units Case Mounted On 4” x 6” x 0.25” Al. Plate Heat Sink. 3. Measured at 1.0 MHZ and applied Reverse Voltage of 4.0V. http://www.luguang.cn mail:[email protected] pF o C/W o o C C GBU801-GBU807 Single Phase 8.0AMP.Glass Passivated Bridge Rectifiers RATINGS AND CHARACTERISTIC CURVES (GBU801 THRU GBU807) FIG.1-MAXIMUM FORWARD CURRENT DERATING CURVE FIG.2- TYPICAL REVERSE CHARACTERISTICS PER BRIDGE ELEMENT 8 6 4 HEAT-SINK MOUNTG 3.2 x 3.2 x 0.12" THK (8.2 x 8.2 x 0.3 cm)AI. PLATE 2 0 50 100 o CASE TEMPERATURE. ( C) PEAK FORWARD SURGE CURRENT. (A) 0 200 150 INSTANTANEOUS REVERSE CURRENT. (mA) 500 FIG.3- MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT PER BRIDGE ELEMENT 10 1 50-400V 600-1000V 0.1 Tj=25 0C 0 80 100 20 40 60 PERCENT OF RATED PEAK REVERSE VOLTAGE. (%) 1000 Tj=150 C 8.3ms Single Half Sine Wave 150 Tj=25 0C 600 125 100 75 50 25 1 2 10 20 5 NUMBER OF CYCLES AT 60Hz 50 100 FIG.5- TYPICAL FORWARD CHARACTERISTICS PER BRIDGE ELEMENT 500 GBU801-GBU804 400 100 50 GBU805-GBU807 25 0 0.1 0.5 1 2 5 10 20 50 100 REVERSE VOLTAGE. (V) 40 INSTANTANEOUS FORWARD CURRENT. (A) 120 FIG.4- TYPICAL JUNCTION CAPACITANCE 175 100 Tj=150 0C 100 0.01 JUNCTION CAPACITANCE.(pF) AVERAGE FORWARD CURRENT. (A) 10 20 10 4 2 1 Tj=25 0C Pulse Width=300ms 1% Duty Cycle 0.4 0.2 0.1 0.6 0.7 0.8 0.9 1.0 1.1 1.2 1.3 INSTANTANEOUSFORWARD VOLTAGE. (V) http://www.luguang.cn mail:[email protected] 200 500 800