UF1010C-UF1080C Ultra Fast Rectifiers VOLTAGE RANGE: 100 --- 800 V CURRENT: 10 A Features TO-220AB 2.8± 0.1 Low cost Diffusde junction Glass passivated chip junction Low forward voltage drop 1.4± 0.2 Easily cleaned with freon, alcohol,Isopropanol and similar solvents The plastic material carries U/L recognition 94V-0 1 8.9± 0.2 19.0± 0.5 ? 3.8± 0.15 High current capability PIN 2 3 13.8± 0.5 2.6± 0.2 3.5± 0.3 z 4.5± 0.2 10.2± 0.2 0.9± 0.1 Mechanical Data 0.5± 0.1 2.5± 0.1 PIN 1 Case:JEDEC TO-220AB PIN 3 Polarity: As marked Weight: 0.071 ounces,2.006 gram CASE PIN 2 Dimensions in millimeters Mounting position: Any MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 ambient temperature unless otherwise specified. Single phase,half wave,60 Hz,resistive or inductive load. For capacitive load,derate by 20%. UF 1010C UF 1020C UF 1030C UF 1040C UF 1060C UF 1080C UNITS Maximum recurrent peak reverse voltage VRRM 100 200 300 400 600 800 V Maximum RMS voltage VRMS 70 140 210 280 420 560 V Maximum DC blocking voltage VDC 100 200 300 400 600 800 V Maximum average forw ard rectified current @TC=100 IF(AV) 10 A IFSM 125 A Peak forw ard surge current 8.3ms single half-sine-w ave superimposed on rated load @TJ=125 Maximum instantaneous forw ard voltage @ 5.0A Maximum reverse current @TA=25 at rated DC blocking voltage @TA=125 VF 1.0 1.3 1.7 10 IR V A 500 Maximum reverse recovery time (Note1) trr 50 100 ns Typical junction capacitance (Note2) CJ 80 50 pF Typical thermal resistance (Note3) RθJA 60 TJ - 55 ----- + 150 TSTG - 55 ----- + 150 Operating junction temperature range Storage temperature range NOTE: 1. Measured with I F=0.5A, I R=1A, I rr=0.25A. 2. Measured at 1.0MHZ and applied rev erse v oltage of 4.0V DC. 3.Thermal resistance junction to ambient http://www.luguang.cn mail:[email protected] /W UF1010C-UF1080C Ultra Fast Rectifiers Ratings AND Charactieristic Curves FIG.1 -- TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC 10 N 1. 50 N 1. trr +0.5A D.U.T. (-) (+) 50VDC (approx) (-) 0 PULSE GENERATOR (NOTE2) OSCILLOSCOPE (NOTE 1) 1 NONINDUCTIVE -0.25A (-) -1.0A 1 c m NOTES:1.RISE TIME = 7ns MAX.INPUT IMPEDANCE = 1M .22pF. JJJJJ2.RISE TIME =10ns MAX.SOURCE IMPEDANCE=50 . SET TIME BASE FOR 10/20 ns/cm FIG.3 -- FORW ARD DERATING CURVE 1 0.1 10 AMPERES AVERAGE FORWARD CURRENT 10 UF 10 30 CUF 10 40 C UF 10 60 CUF 10 80 C UF 101 0C -UF 102 0C 100 AMPERES INSTANTANEOUS FORWARD CURRENT FIG.2 -- TYPICAL FORW ARD CHARACTERISTIC 5 Single Phase Half Wave 60H Z Resistive or Inductive Load 0 0 25 .6 .8 1.0 1.2 1.4 1.6 125 150 175 CASE TEMPERATURE, FIG.4 -- TYPICAL JUNCTION CAPACITANCE 600 400 200 100 60 40 TJ=25 f=1MHz 0.4 1 2 4 10 20 40 100 REVERSE VOLTAGE,VOLTS http://www.luguang.cn 150 125 8.3ms Single Half Sine-Wave 100 AMPERES 1000 FIG.5 -- PEAK FORW ARD SURGE CURRENT PEAK FORWARD SURGE CURRENT JUNCTION CAPACITANCE,pF 100 1.8 INSTANTANEOUS FORW ARD VOLTAGE, VOLTS 10 0.1 0.2 75 Tj=25oC Pulse Width=300 s 1% Duty Cycle 0.01 .4 20 50 75 50 25 0 1 5 10 20 50 100 NUMBER OF CYCLES AT 60Hz mail:[email protected] z