FR510-FR560 Fast Recovery Rectifiers VOLTAGE RANGE: 100 --- 600 V CURRENT: 5.0 A TO - 220AC 2.8± 0.1 Features Low cost Diffused junction Low leakage Low forward voltage drop High current capability Easily cleaned with Freon,Alcohol,Isopropanol and similar solvents The plastic material carries U/L recognition 94V-0 4.5± 0.2 10.2± 0.2 1.4± 0.2 8.9± 0.2 19.0± 0.5 φ 3.8± 0.15 PIN 1 2 Mechanical Data 13.8± 0.5 3.5± 0.3 2.6± 0.2 0.9± 0.1 Case:JEDEC TO-220AC,molded plastic 5.0± 0.1 0.5± 0.1 Polarity: Color band denotes cathode Weight: 0.064 ounces,1.81 gram Mounting position: Any Dimensions in millimeters MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 ambient temperature unless otherwise specified. Single phase,half wave,60 Hz,resistive or inductive load. For capacitive load,derate by 20%. FR 510 FR 520 FR 540 FR 560 UNITS 600 V Maximum recurrent peak reverse voltage VRRM 100 200 400 Maximum RMS voltage VRMS 70 140 280 420 V Maximum DC blocking voltage V DC 100 200 400 600 V Maximum average forw ard rectified current @TA=75 IF(AV) 5.0 A IFSM 100 A VF 1.3 V Peak forw ard surge current 8.3ms single half-sine-w ave superimposed on rated load @TJ =125 Maximum instantaneous forw ard voltage @ 5.0 A Maximum reverse current at rated DC blocking voltage @TA =25 @TA =100 10 IR 250 150 Maximum reverse recovery time (Note1) t rr Typical junction capacitance (Note2) CJ 28 Typical thermal resistance (Note3) RθJA 3.5 TJ - 55---- +150 TSTG - 55---- + 150 Operating junction temperature range Storage temperature range NOTE:1. Measured with I F =0.5A, I R=1A, I rr=0.25A. 2. Measured at 1.0MHz and applied rev erse v oltage of 4.0V DC. 3. Thermal resistance f rom junction to ambient. http://www.luguang.cn A 150 mail:[email protected] ns pF ／Ｗ FR510-FR560 Fast Recovery Rectifiers Ratings AND Charactieristic Curves FIG.2--PEAK FORWARD SURGE CURRENT PEAK FORWARD SURGE CURRENT AMPERES AVERAGE FORWARD RECTIFIED CURRENT AMPERES FIG.1 -- FORWARD DERATING CURVE 8 7 6 5 4 3 2 Single Phase H alf W ave 60H Z R esistive or Inductive Load 1 0 0 25 50 75 10 0 12 5 15 0 17 5 50 25 0 INSTANTANEOUS FORWARD CURRENT AMPERES 40 20 10 TJ=25 f=1MHz 2 1 .2 .4 1.0 2 4 10 20 40 4 8 10 20 40 60 80 100 FIG.4 --TYPICAL FORWARD CHARACTERISTIC 60 .1 2 1 NUMBER OF CYCLES AT 60 Hz 100 4 TJ=125 8.3ms Single Half Sine-Wave 75 AMBIENT TEMPERATURE, FIG.3--TYPICAL JUNCTION CAPACITANCE JUNCTION CAPACITANCE,pF 100 100 REVERSE VOLTAGE,VOLTS 100 10 TJ=25 Pulse Width=300µS 4 2 1.0 0.4 0.2 0.1 0.06 0.04 0.02 0.01 0.5 0.7 0.9 1.1 1.3 1.5 1.7 INSTANTANEOUS FORWARD VOLTAGE,VOLTS FIG.5 -- REVERSE RECOVERY TIME CHARACTERISTIC AND TEST CIRCUIT DIAGRAM trr 10 N.1. 50 N.1. +0.5A D.U.T. ( - ) 0 PULSE GENERATOR (NOTE2) (+) 50VDC (APPROX) (-) 1 N.1. 1.9 OSCILLOSCOPE (NOTE 1) -0.25A ( + ) -1.0A 1cm NOTES:1.RISETIME=7ns MAX. INPUT IMPEDANCE=1M .22pF SET TIMEBASEFOR50/100 ns /cm 2.RISETIME=10ns MAX. SOURCEIMPEDANCE=5O http://www.luguang.cn mail:[email protected]