ARINC Filter Connectors 404 and 600 ARINC 404 & 600 Filter Connectors DESIGN BENEFITS INTRODUCTION CarlisleIT manufactures ARINC 404 and ARINC 600 filter connectors with QPL’d interfaces, front removable, front release size 22 contacts and modular construction. Depending on performance requirements these connectors can be designed using either planar or chip-on-board technologies. All meet ARINC specification requirements, are available in all the standard arrangements and come with PC tail, solder cup, crimp or wire wrap termination. » Front release front removable #22 contacts » Planar and/or Chip on Board design » Ferrite immobilization » Modular filter backpack/standard shell construction » Can incorporate filtering plus Transient Voltage Suppression DESIGN CONSIDERATIONS Rectangular Mating End Contacts Filter Types* Electrical ARINC 404 Pin C Feed Thru Contacts ARINC 600 Socket C/Pi Pi Pi/TVS Mounting Hardware Contact Terminations Thermal Cycle Clinch Nut PC Tails Ground Contacts Thermal Shock Helicoil Soldercup DWV min ____ VDC Burn-in Crimp SEALED Wire Wrap Environmental TVS * Maximum or Mixed Capacitance Requirement? ____pF Carlisle Interconnect Technologies / 102 West Julie Drive, Tempe, AZ 85283 Phone - 480.730.5700 / Fax - 480.730.5800 / CarlisleIT.com ARINC Filter Connectors Insertion Loss (dB) 0.0 11 0 Frequency (MHz) 100 1000 -10.0 PL -20.0 PM -30.0 PT PH -40.0 PVH -50.0 -60.0 -70.0 0.0 Insertion Loss (dB) ‘C’ Type Filter Attenuation ‘Pi’ Type Filter Attenuation ATTENUATION GRAPHS 11 0 Frequency (MHz) 100 1000 -10.0 CL -20.0 CM -30.0 CT CH -40.0 CVH -50.0 -60.0 -70.0 Integrated structure with ARINC trays and connectors Carlisle Interconnect Technologies / 102 West Julie Drive, Tempe, AZ 85283 Phone - 480.730.5700 / Fax - 480.730.5800 / CarlisleIT.com © Carlisle Interconnect Technologies, 2012. All trademarks, service marks and trade names are property of their respective holding companies. All Rights Reserved. Rev. 072312-2000