Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: [email protected] Web: http://www.frontierusa.com 2A FAST RECOVERY PLASTIC RECTIFIER BY296 THRU BY299 FEATURES z LOW COST z UL 94V0 FLAME RETARDANT EPOXY MOLDING COMPOUND z DIFFUSED JUNCTION z HIGH SURGE CURRENT CAPABILITY 1.0(25.4) MIN .052(1.3) .048(1.2) .375(9.5) .335(8.5) .220(5.6) .197(5.0) MECHANICAL DATA z CASE: TRANSFER MOLDED, DO201AD, DIMENSIONS IN INCHES AND (MILLIMETERS) z LEADS: SOLDERABLE PER MIL-STD-202,METHOD 208 z POLARITY: CATHODE INDICATED BY COLOR BAND z WEIGHT: 1.2 GRAMS 1.0(25.4) MIN MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS RATINGS AT 25°C AMBIENT TEMPERATURE UNLESS OTHERWISE SPECIFIED SINGLE PHASE, HALF WAVE, 60 HZ, RESISTIVE OR INDUCTIVE LOAD. FOR CAPACITIVE LOAD, DERATE CURRENT BY 20% RATINGS MAXIMUM RECURRENT PEAK REVERSE VOLTAGE MAXIMUM RMS VOLTAGE MAXIMUM DC BLOCKING VOLTAGE MAXIMUM AVERAGE FORWARD RECTIFIED CURRENT 0.375”(9.5mm) LEAD LENGTH AT TA=55°C PEAK FORWARD SURGE CURRENT, 8.3ms SINGLE HALF SINE-WAVE SUPERIMPOSED ON RATED LOAD TYPICAL JUNCTION CAPACITANCE (NOTE 1) SYMBOL BY296 BY297 BY298 BY299 UNITS VRRM VRMS VDC 100 70 100 200 140 200 400 280 400 600 420 600 V V V IO 2.0 A IFSM 70 A CJ 60 PF TYPICAL THERMAL RESISTANCE (NOTE 2) Rθja 25 ℃/W STORAGE TEMPERATURE RANGE TSTG - 55 TO + 150 ℃ OPERATING TEMPERATURE RANGE TOP - 55 TO + 150 ℃ ELECTRICAL CHARACTERISTICS (AT TA =25°C UNLESS OTHERWISE NOTED) CHARACTERISTICS SYMBOL BY296 BY297 BY298 BY299 UNITS MAXIMUM FORWARD VOLTAGE AT IO DC VF 1.3 V MAXIMUM REVERSE CURRENT AT 25℃ IR 10 μA MAXIMUM REVERSE CURRENT AT 100℃ IR 100 μA MAXIMUM REVERSE RECOVERY TIME (NOTE 3) TRR NOTE: 1. MEASURED AT 1 MHZ AND APPLIED REVERSE VOLTAGE 0F 4.0 VOLTS 150 250 2. BOTH LEADS ATTACHED TO HEAT SINK 35×35×1t(mm) COPPER PLATE AT LEAD LENGTH 5mm 3. REVERSE RECOVERY TEST CONDITIONS: IF=0.5A, IR=1.0A, IRR=0.25A BY296 THRU BY299 Page: 1 nS RATINGS AND CHARACTERISTIC CURVE BY329X-1500 THRU BY329X-1500S FIG. 1 -TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC 50Ω NO INDUCTIVE 10Ω NO INDUCTIVE Trr (-) +0.5A D.U.T. (+) 25 Vdc (approx) (-) PULSE GENERATOR ( NOTE 2 ) 1Ω NON INDUCTIVE OSCILLOSCOPE ( NOTE 1 ) 0 -0.25A (+) -1.0A NOTE: 1. RISE TIME=7ns MAX. INPUT IMPEDANCE=1 MOhms 22PF 2. RISE TIME =10 ns MAX. SOURCE IMPEDANCE=50 OHMS 1cm SET TIME BASE FOR 10/20 ns/cm FIG. 3 -TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS FIG. 2 -TYPICAL FORWARD CURRENT DERATING CURVE 7.5 AVERAGE FORWARD CURRENT (A) 6.0 4.5 3.0 1.5 0 Single Phase Half Wave 60Hz Resistive or Inductive Load 25 50 75 100 125 150 175 INSTANTANEOUS FORWARD CURRENT (A) 100 9.0 10 1.0 .1 .01 0 .2 FIG. 4 -TYPICAL REVERSE CHARACTERISTICS .6 .8 1.0 1.2 1.4 1.6 1.8 FIG. 5 -TYPICAL JUNCTION CAPACITANCE 200 100 TJ=125oC JUNCTION CAPACITANCE (pF) INSTANTANEOUS REVERSE CURRENT (uA) .4 INSTANTANEOUS FORWARD VOLTAGE (V) CASE TEMPERATURE (oC) 10 1 TJ=25oC 0.1 0.01 100 40 TJ=25oC 20 10 6 4 2 1 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE (%) .1 .2 .4 1.0 2 4 10 20 40 REVERSE VOLTAGE (V) BY296 THRU BY299 Page: 2 100