Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: [email protected] Web: http://www.frontierusa.com 8A SUPER FAST RECOVERY RECTIFIER SFF80-03-LFR THRU SFF80-06-LFR CASE: ITO-220AC ( SFF80-XX ) , FULLY INSULATED PACKAGE B O J C K B C D E F G H I J K L M O D 1 2 F H E M I G PIN 1 MILLIMETERS MIN MAX 9.72 10.27 6.30 6.90 14.50 15.50 13.00 13.80 4.1 4.95 5.20 1.52 0.9 4.8 3.1 2.5 2.9 0.8 Ø 3.4 L PIN 2 CASE FEATURES z ULTRA FAST RECOVERY TIME z LOW FORWARD VOLTAGE z LOW THERMAL RESISTANCE z HIGH CURRENT CAPABILITY z HIGH VOLTAGE z GLASS PASSIVATED CHIP JUNCTION z ROHS MECHANICAL DATA z CASE: TRANSFER MOLDED z TERMINAL: MIL-STD-202F METHOD 208 z POLARITY: AS MARKED z EPOXY: UL94V-0 FLAME RETARDANT MOLDING COMPOUND z MOUNTING POSITION: ANY z WEIGHT 1.81 GRAMS MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS RATINGS AT 25°C AMBIENT TEMPERATURE UNLESS OTHERWISE SPECIFIED SINGLE PHASE, HALF WAVE, 60 HZ, RESISTIVE OR INDUCTIVE LOAD. FOR CAPACITIVE LOAD, DERATE CURRENT BY 20% RATINGS SYMBOL SFF80-03-LFR SFF80-04-LFR SFF80-05-LFR SFF80-06-LFR UNITS MAXIMUM RECURRENT PEAK REVERSE VOLTAGE MAXIMUM RMS VOLTAGE MAXIMUM DC BLOCKING VOLTAGE MAXIMUM AVERAGE FORWARD RECTIFIED CURRENT SEE FIG.1 PEAK FORWARD SURGE CURRENT, 8.3ms SINGLE HALF SINE-WAVE SUPERIMPOSED ON RATED LOAD TYPICAL JUNCTION CAPACITANCE (NOTE 1) TYPICAL THERMAL RESISTANCE (NOTE 2) VRRM VRMS VDC 300 210 300 400 280 400 500 350 500 600 420 600 V V V IO 8.0 A IFSM 125 A CJ Rθjc 65 2.2 STORAGE TEMPERATURE RANGE TSTG - 55 TO + 150 OPERATING TEMPERATURE RANGE TOP - 55 TO + 150 PF °C /W °C °C ELECTRICAL CHARACTERISTICS (AT TA =25°C UNLESS OTHERWISE NOTED) CHARACTERISTICS SYMBOL SFF80-03-LFR SFF80-04-LFR MAXIMUM FORWARD VOLTAGE AT IO PER LEG VF 1.30 MAXIMUM DC REVERSE CURRENT AT TA=25°C IR MAXIMUM DC REVERSE CURRENT AT TA=100°C IR MAXIMUM REVERSE RECOVERY TIME (NOTE 3) TRR NOTES: 1. MEASURED AT 1 MHZ AND APPLIED REVERSE VOLTAGE 0F 4.0 VOLTS 2. THERMAL RESISTANCE JUNCTION TO CASE PER LEG MOUNTED ON HEAT SINK SFF80-03-LFR THRU SFF80-06-LFR 1 SFF80-05-LFR SFF80-06-LFR 1.70 10 100 35 UNITS V μA μA nS Page: 3. REVERSE RECOVERY TEST CONDITIONS: IF=0.5A, IR=1.0A, IRR=0.25A RATINGS AND CHARACTERISTIC CURVE SFF80-03-LFR THRU SFF80-06-LFR FIG. 1 -TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC 50Ω NO INDUCTIVE 10Ω NO INDUCTIVE Trr (-) +0.5A D.U.T. (+) 25 Vdc (approx) (-) PULSE GENERATOR ( NOTE 2 ) 1Ω NON INDUCTIVE OSCILLOSCOPE ( NOTE 1 ) 0 -0.25A (+) -1.0A NOTE: 1. RISE TIME=7ns MAX. INPUT IMPEDANCE=1 MOhms 22PF 2. RISE TIME =10 ns MAX. SOURCE IMPEDANCE=50 OHMS 1cm SET TIME BASE FOR 10/20 ns/cm FIG. 3 -TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS FIG. 2 -TYPICAL FORWARD CURRENT DERATING CURVE 100 INSTANTANEOUS FORWARD CURRENT (A) 12 AVERAGE FORWARD CURRENT (A) 10 8 6 4 2 0 Single Phase Half Wave 60Hz Resistive or Inductive Load 25 50 75 100 125 150 175 10 SFF80-03-LF~04-LF 1.0 .01 0 .2 TJ=125oC TJ=80oC TJ=25oC 1 SFF80-03-LFR THRU 20 40 60 80 SFF80-06-LFR 100 120 140 2PERCENT OF RATED PEAK REVERSE VOLTAGE (%) JUNCTION CAPACITANCE (pF) INSTANTANEOUS REVERSE CURRENT (uA) .8 1.0 1.2 1.4 1.6 1.8 200 1000 0.1 .6 FIG. 5 -TYPICAL JUNCTION CAPACITANCE FIG. 4 -TYPICAL REVERSE CHARACTERISTICS 10 .4 INSTANTANEOUS FORWARD VOLTAGE (V) CASE TEMPERATURE (oC) 100 SFF80-05-LF~06-LF .1 100 40 20 10 6 4 TJ=25oC 2 1 Page: .1 .2 .4 1.0 2 4 10 20 40 REVERSE VOLTAGE (V) 100