PRODUCT SUMMARY CX74063: RF Transceiver With Integrated Crystal Oscillator and Power Ramping Controller for Multi-Band GSM, GPRS, and EDGE Applications Applications Description • GSM850, EGSM900, DCS1800, and PCS1900 handsets • GPRS handsets and modules • EDGE downlink support The CX74063 transceiver is a highly integrated device for multiband Global System for Mobile Communications (GSM) or General Packet Radio Service (GPRS) applications. The device requires a minimal number of external components to complete a GSM radio subsystem. The CX74063 supports GSM850, EGSM900, DCS1800, and PCS1900 applications. The receiver also supports downlink Enhanced Data-Rate GSM Evolution (EDGE). Features • Direct down-conversion receiver eliminates the external image reject/IF filters • Three separate LNAs with single-ended inputs • RF gain range: GSM = 20 dB, DCS/PCS = 22 dB. Baseband gain range = 100 dB • Gain selectable in 2 dB steps • Integrated receive baseband filters with tunable bandwidth • Integrated DC offset correction sequencer • Reduced filtering requirements with translational loop transmit architecture • Integrated transmit VCOs • Wide RF range for quad band operation • Integrated PAC loop • Single integrated, fully programmable fractional-N synthesizer suitable for multi-slot GPRS operation • Fully integrated wideband UHF VCO • Integrated crystal oscillator • Separate enable lines for power management transmit, receive, and synthesizer modes • Supply voltage down to 2.6 V • Band select and front-end enable states may be exercised on output pins to control external circuitry • Low external component count • Optional bypass of baseband filtering for use with high dynamic range ADCs for current savings • Interfaces to low dynamic range ADC • Meets AM suppression requirements without baseband interaction • 56-pin RFLGA 8x8 mm package • Low power standby mode The receive path implements a direct down-conversion architecture that eliminates the need for Intermediate Frequency (IF) components. The CX74063 receiver consists of three integrated Low Noise Amplifiers (LNAs), a quadrature demodulator, tunable receiver baseband filters, and a DC-offset correction sequencer. In the transmit path, the device consists of an In-phase and Quadrature (I/Q) modulator within a frequency translation loop designed to perform frequency up-conversion with high output spectral purity. This loop also contains a phase-frequency detector, charge pump, mixer, programmable dividers, and high power transmit Voltage Controlled Oscillators (VCOs) with no external tank required. With the integrated gain controller (and an integrator ), the device realizes the Power Amplifier Control (PAC) functionality when combined with a coupler, a Radio Frequency (RF) detector and a Power Amplifier (PA). The CX74063 also features an integrated, fully programmable, sigma-delta fractional-N synthesizer suitable for GPRS multi-slot operation. Except for the loop filter, the frequency synthesizer function, including a wideband VCO, is completely on-chip. The reference frequency for the synthesizer is supplied by the integrated crystal oscillator circuitry. The CX74063 is available as a 56-pin RFLGA™ 8x8 mm package with either a circular ground pad or a four-quadrant ground pad. Package dimensions are shown in Figures 1 and 2. Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [email protected] • www.skyworksinc.com 103008B • Skyworks Proprietary and Confidential information • Products and product information are subject to change without notice • January 27, 2004 1 PRODUCT SUMMARY • CX74063 0.38 ± 0.08 8.00 ± 0.10 8.00 ± 0.10 Pin 1 Pin 1 0.38 ± 0.08 Pin 1 0.56 Ref Pin 1 R2.70 Ref R2.70 Ref 0.50 Ref 0.50 Ref 8.00 ± 0.10 8.00 ± 0.10 R0.25 (12x) 0.30 ± 0.05 Top View 0.30 ± 0.05 Bottom View Top View 1.00 ± 0.10 Bottom View 1.00 ± 0.10 Side View Side View All dimensions are in millimeters C1339 Figure 1. CX74063 56-Pin RFLGA Package Dimensions (Circular Ground Pad) All dimensions are in millimeters S288 Figure 2. CX74063 56-Pin RFLGA Package Dimensions (Four-Quad Ground Pad) Ordering Information Model Name CX74063 Manufacturing Part Number Product Revision CX74063-34: MSL3/240, circular ground pad CX74063-35: MSL3/260, circular ground pad CX74063-36: MSL3/260, four-quadrant ground pad Copyright © 2001, 2002, 2004 Skyworks Solutions, Inc. All Rights Reserved. Information in this document is provided in connection with Skyworks Solutions, Inc. (“Skyworks”) products. These materials are provided by Skyworks as a service to its customers and may be used for informational purposes only by the customer. Skyworks assumes no responsibility for errors or omissions in these materials. Skyworks may make changes to its documentation, products, specifications and product descriptions at any time, without notice. Skyworks makes no commitment to update the information and shall have no responsibility whatsoever for conflicts, incompatibilities, or other difficulties arising from future changes to its documentation, products, specifications and product descriptions. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted by or under this document. Except as may be provided in Skyworks’ Terms and Conditions of Sale for such products, Skyworks assumes no liability whatsoever in association with its documentation, products, specifications and product descriptions. THESE MATERIALS ARE PROVIDED “AS IS” WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED OR OTHERWISE, RELATING TO SALE AND/OR USE OF SKYWORKS PRODUCTS INCLUDING WARRANTIES RELATING TO FITNESS FOR A PARTICULAR PURPOSE, MERCHANTABILITY, PERFORMANCE, QUALITY OR NON-INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. SKYWORKS FURTHER DOES NOT WARRANT THE ACCURACY OR COMPLETENESS OF THE INFORMATION, TEXT, GRAPHICS OR OTHER ITEMS CONTAINED WITHIN THESE MATERIALS. SKYWORKS SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, INCLUDING WITHOUT LIMITATION, LOST REVENUES OR LOST PROFITS THAT MAY RESULT FROM THE USE OF THESE MATERIALS WHETHER OR NOT THE RECIPIENT OF MATERIALS HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. Skyworks products are not intended for use in medical, lifesaving or life-sustaining applications. Skyworks’ customers using or selling Skyworks products for use in such applications do so at their own risk and agree to fully indemnify Skyworks for any damages resulting from such improper use or sale. The following are trademarks of Skyworks Solutions, Inc.: Skyworks™, the Skyworks logo, and Breakthrough Simplicity™. Product names or services listed in this publication are for identification purposes only, and may be trademarks of Skyworks or other third parties. Third-party brands and names are the property of their respective owners. Additional information, posted at www.skyworksinc.com, is incorporated by reference. Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [email protected] • www.skyworksinc.com 2 January 27, 2004 • Skyworks Proprietary and Confidential information • Products and product information are subject to change without notice • 103008B