Proximity Sensors Inductive High Temperature Types IA, M5, 8, NPN/PNP • Stainless steel housings • Sensing distance: 0.8 - 1 mm • Power supply: 10 to 30 VDC • Output: Transistor NPN or PNP, make switching • For flush mounting • 2 m silicone cable Product Description Ordering Key IA 05 BSF 08 NO HT-K Inductive proximity sensor with transistor output in M5 and M8 stainless steel housing for flush mounting in metal. Type: Ind. prox. switch Housing style Housing size Housing material Housing length Detection principle Sensing distance Output type Output configuration High temperature Output configuration for NPN/PNP with NO as standard. Connection with 2 m silicone cable. Type Selection Rated operating dist. (Sn) Connection type Housing dimensions Ordering no. Transistor NPN Make switching Ordering no. Transistor PNP Make switching 0.8 mm 1.0 mm Cable, 2 m Cable, 2 m M5 M8 IA 05 BSF 08 NOHT-K IA 08 BSF 10 NOHT-K IA 05 BSF 08 POHT-K IA 08 BSF 10 POHT-K Ambient temperature Operating Storage Degree of protection Housing material CE-marking Connection -25 to +120°C (-13 to +248°F) -30 to +125°C (-22 to +257°F) IP 67 (Nema 1, 3, 4, 6, 13) Stainless steel Yes Cable, silicone, 2 m, AWG 26 All types for flush mounting in metal Specifications Rated operational volt. (UB) Ripple Rated operational current (Ie) Continuous No-load supply current (Io) Voltage drop (Ud) Frequency of op. cycles (f) Effective operating dist. (Sr) Usable operating dist. (Su) 10 to 30 VDC (ripple included) ≤ 10% ≤ 50 mA @ + 25°C (+75°F) ≤ 5 mA (ON) < 3,0 V (@ Imax) Ø5: 3 kHz Ø8: 2 kHz 0.9 x Sn ≤ Sr ≤ 1.1 x Sn 0.85 x Sr ≤ Su ≤ 1.15 x Sr Specifications are subject to change without notice (07.12.00) 1 IA M5, 8, NPN/PNP Dimensions Wiring Diagrams M8 x 1 M5 x 0,5 1 BN + 1 BN + 4 BK 25 30 45 4 BK 3 BU IA 05 BSF 08 .OHT-K IA 08 BSF 10 .OHT-K 3 BU - NPN - Make switching - PNP - Make switching Installation Hints To avoid interference from inductive voltage/ current peaks, separate the prox. switch power cables from any other power cables, e.g. motor, contactor or solenoid cables Relief of cable strain Protection of the sensing face Switch mounted on mobile carrier A proximity switch should not serve as mechanical stop Any repetitive flexing of the cable should be avoided Incorrect Correct The cable should not be pulled 2 Specifications are subject to change without notice (07.12.00)