Preliminary Data Sheet PJ2109 QUDA OPERATIONAL AMPLIFIER AND PROGRAMMABLE VOLTAGE REFERENCE The PJ2109 is a monolithic IC that includes four op-amp and an adjustable shunt voltage reference. This device is DIP-16 SOP-16 offering space and cost saving in many applications like power supply management or data acquisition systems. FEATURES Low Supply Current: 375µA/op (@Vcc=5V). Low Input Bias Current:20nA Medium Speed:0.9MHz Low Input Offset Voltage:0.5mV Typ For PJ2109 Wide Power Supply Range:±1.5V To ±15V Adjustable Output Voltage: Vref To 36V 0.4% And 1% Voltage Precision Sink Current Capability:1 To 100mA Typical Output Impedance:0.2Ω Pin: 1.Output1 2. Inverting Input1 3. Non-inverting Input1 4. VCC+ 5. Non-inverting Input2 6. Inverting Input2 7. Output2 8. Adjust 9.Cathode 10.Output3 11. Inverting Input3 12.Non-inverting Input3 13.VCC14.Non-inverting Input4 15.Inverting Input 16.Output4 ORDERING INFORMATION APPLICATIONS Battery protection Load switch Power management Device PJ2109CD PJ2109CS Operating Temperature 0 TO 75℃ BLOCK DIAGRAM 1-5 2002/12.rev.A Package DIP16 SOP16 Preliminary Data Sheet PJ2109 QUDA OPERATIONAL AMPLIFIER AND PROGRAMMABLE VOLTAGE REFERENCE MAXIMUM RATINGS Parameter Symbol Value Unit Supply Voltage Vcc 36 V Differential Input Voltage Iid 36 V Input Voltage Vi -0.3 to 36 V Output short-circuit Duration Infinite Operating Free-Air Temperature Range Maximum Junction Temperature Thermal Resistant Junction to Ambient(SO package) Ioper -55 to +125 ℃ Tj 150 ℃ Tthja 150 ℃/W ELECTRICAL CHARACTERISTICS(Vcc+=5V, Vcc-=0V, Tamb=25℃(unless otherwise specified)) CHARACTERISTICS SYMBOL CONDITIONS Min. Typ. Max. 1.4 2.4 Unit + Vcc =5V, no load Total Supply Current, excluding current in the Voltage Reference Icc Tmin.<Tamb.<Tmax. mA Vcc+=30V, no load 4 Tmin.<Tamb.<Tmax. 2-5 2002/12.rev.A Preliminary Data Sheet PJ2109 QUDA OPERATIONAL AMPLIFIER AND PROGRAMMABLE VOLTAGE REFERENCE ELECTRICAL CHARACTERISTICS(Vcc+=5V, Vcc-=Ground, Vo=1.4V, Tamb=25℃(unless otherwise specified)) CHARACTERISTICS SYMBOL CONDITIONS VCC=15V, RL=2K Min. Typ. Max. Unit 50 100 V/mV 65 100 dB 70 85 dB Large Signal Voltage Gain Avd Supply Voltage Rejection Ratio SVR Common Mode Rejection Ratio CMR Input Voltage Mode Voltage Range Vicm Input Offset Voltage Vio 1 △Vio 7 Input Offset Current Iio 2 30 nA Input Bias Current Iib 20 150 nA Input Offset Voltage Drift Output Current Source Isource VO=1.4V to 11.4V VCC=5V to 3V VCC= +30V see note1) VO=2V,VCC=+15V,Vid=+1V Output Short Circuit to Ground IO VCC=+15V Output Current Sink Isink Vid = -1V, VCC=+15V,VO=+2V Low Level Output Voltage VOL RL=10K High Level Output Voltage VOH RL=10K,VCC+=30V Channel Separation CS Gain Bandwith Product GBP Slew Rate at Unity Gain SR Equivalent en 0 20 f=100kHz,Vin=10mV Vi=0.5 to 3V,VCC=15V RL=2KΩ,CL=100Pf,unity gain V 5 mV 10 mA 60 mA 20 5 27 µV/℃ 40 40 mA 20 mV 28 V 120 dB 0.5 0.9 MHz 0.1 0.3 V/µs 1kHz<f<20kHz VCC=30V,RL=2K,CL=100Pf VCC+-1.5 f=1kHz,VCC=30V,RS=100Ω nV 50 Hz f=1kHz, Total Harmonic Distortion THD AV=20dB,RL=2,VCC=30V 0.02 % CL=100pF,VO=2Vpp Cathode Current Reference Input Voltage Reference Input Voltage Deviation Over Temperature Range IK 1 Vref 2.475 △Vref VKA=Vref,,IK=10mA 100 mA 2.5 2.525 V 7 30 mV Ratio of Change in Reference Input Voltage to Charge in Cathode to △Vref/△VKA IK=10mA,△VKA=36V to 3V -2 -1.1 mV/V Anode Voltage 1. The input common-mode voltage of either input signal voltage should not be allowed to go negative by more than 0.3V. The upper end of the common-mode voltage range is Vcc+. But either of both inputs can go to +36V without damage. 3-5 2002/12.rev.A Preliminary Data Sheet PJ2109 QUDA OPERATIONAL AMPLIFIER AND PROGRAMMABLE VOLTAGE REFERENCE ELECTRICAL CHARACTERISTICS(Vcc+=5V, Vcc-=Ground, Vo=1.4V, Tamb=25℃(unless otherwise specified)) CHARACTERISTICS Minimum Cathode Current for Regulation SYMBOL Imin Off-State Cathode Current Ioff Reference Input Current Iref Reference Input Current Deviation Over TO Range Dynamic Impedance-note1 CONDITIONS VKA=Vref IK=10mA △Iref ∣ZKA∣ VKA=Vref, △IK=1 to 100mA f<1kHz 4-5 Min. Typ. Max. Unit 0.5 1 mA 180 500 nA 1.5 2.5 µA 0.8 1.2 µA 0.2 0.5 Ω 2002/12.rev.A Preliminary Data Sheet PJ2109 QUDA OPERATIONAL AMPLIFIER AND PROGRAMMABLE VOLTAGE REFERENCE DIP-16 Unit：mm DIP-16 DIMENSION A MILLIMETERS INCHES DIM 16 MIN MAX MIN MAX A 17.80 18.05 0.701 0.710 B 6.25 6.45 0.292 0.299 C 2.35 2.65 0.093 0.104 D 0.35 0.49 0.014 0.019 9 B 1 8 L N C G J J 0.25 0.32 0.010 0.012 K 0.10 0.25 0.004 0.009 L 7.75 8.00 0.305 0.315 N 0.39 1.01 0.015 0.039 K G 0.05BSC 1.27BSC D SOP-16 Unit：mm SOP-16 DIMENSION MILLIMETERS A MIN MAX MIN MAX A 9.8 10.00 0.386 0.393 B 7.40 7.60 0.292 0.299 C 2.35 2.65 0.093 0.104 D 0.35 0.49 0.014 0.019 F 0.50 0.90 0.020 0.035 9 16 B 1 P 8 G R C D INCHES DIM K F 5-5 0.05BSC 1.27BSC K 0.10 0.25 M 0° 7° 0° P 10.05 10.55 0.395 0.415 R 0.25 0.75 0.010 0.029 2002/12.rev.A 0.004 0.009 7°