E15C7 Series E15C7 • RoHS Compliant (Pb-Free) • LVPECL output oscillators • 2.5V supply voltage • Ceramic 6-pad SMD package • Stability to ±25ppm • Tri-State output • Complementary output • Available on tape and reel • Wide range of available frequencies H L W 2.0 7.0 5.0 OSCILLATOR ELECTRICAL SPECIFICATIONS Nominal Frequency (MHz) Operating Temperature Range Storage Temperature Range Supply Voltage (VCC) Input Current Frequency Tolerance / Stability Output Voltage Logic High (VOH) Output Voltage Logic Low (VOL) Rise Time / Fall Time Duty Cycle Load Drive Capability Logic Control / Additional Output Tri-State Input Voltage Standby Current Start Up Time RMS Phase Jitter Typical Phase Noise 77.760M, 78.125M, 80M, 80.157M, 85M, 87.125M, 90M, 100M, 106.25M, 110M, 119M, 120M, 122.888M, 124.4M, 125M, 127M, 128M, 133M, 133.333M, 137.472M, 150M, 155.52M, 156.25M, 159.375M, 161.1328M, 162.5M , 166M, 170M, 175M, 176.83816M, 187.5M, 187.509375M, 200M, or 212.5MHz Inclusive of All Conditions: Calibration Tolerance at 25°C, Frequency Stability over the Operating Temperature Range, Supply Voltage Change, Output Load Change, 1st Year Aging at 25°C, Shock, and Vibration 0°C to 85°C -40°C to 0°C 0°C to 85°C -40°C to 0°C 20% to 80% of waveform at 50% of waveform VIH of 70% of VCC Minimum No Connection VIL of 30% of VCC Maximum Without Load FJ = 12kHz to 20MHz Fo=156.250MHz 0°C to 70°C, or -40°C to +85°C -55°C to 125°C 2.5VDC ±5% 75mA Maximum ±100ppm, ±50ppm, or ±25ppm Maximum VCC-1.025VDC Minimum VCC-1.085VDC Minimum VCC-1.405VDC Maximum VCC-1.305VDC Maximum 300pSec Typical, 700pSec Maximum 50 ±5(%) 50 Ohms into VCC-2.0VDC Complementary Output and Tri-State Enables Output Enables Output Disables Output: High Impedance 30µA Maximum 10 mSeconds Maximum 0.4pSec Typical, 1 pSec Maximum -60dBc/Hz at 10Hz Offset -95dBc/Hz at 100Hz Offset -125dBc/Hz at 1kHz Offset -143dBc/Hz at 10kHz Offset -145dBc/Hz at 100kHz Offset -145dBc/Hz at 1MHz Offset -146dBc/Hz at 10MHz Offset MANUFACTURER CATEGORY SERIES PACKAGE VOLTAGE CLASS REV.DATE ECLIPTEK CORP. OSCILLATOR E15C7 CERAMIC 2.5V OS1C 01/07 800-ECLIPTEK www.ecliptek.com for latest revision Specifications subject to change without notice. PART NUMBERING GUIDE E15C7 E 2 F - 155.520M TR FREQUENCY TOLERANCE & STABILITY/ OPERATING TEMPERATURE RANGE C=±100ppm Maximum over 0°C to +70°C D=±50ppm Maximum over 0°C to +70°C E=±25ppm Maximum over 0°C to +70°C G=±100ppm Maximum over -40°C to +85°C H=±50ppm Maximum over -40°C to +85°C J=±25ppm Maximum over -40°C to +85°C (*) AVAILABLE OPTIONS Blank=Tubes TR=Tape and Reel (Standard) FREQUENCY LOGIC CONTROL/ADDITIONAL OUTPUT F=Complementary Output and Tri-State DUTY CYCLE 2=50 ±5(%) (*) Not available over Nominal Frequency range of 176.83816MHz to 212.500MHz MECHANICAL DIMENSIONS SUGGESTED SOLDER PAD LAYOUT ALL DIMENSIONS IN MILLIMETERS ALL DIMENSIONS IN MILLIMETERS 5.00 ±0.20 2.00 MAX 2.60 +0.40/-0.60 MARKINING ORIENTATION 2.54 ±0.10 7.00 +0.70/ 5.08 -0.15 ±0.20 6 1 5 2 4 Pin 1: Tri-State Pin 2: No Connect Pin 3: Case Ground TAPE AND REEL DIMENSIONS 3 1.2 +0.3/ -0.2 1.4 ±0.2 Pin 4: Output Pin 5: Complementary Output Pin 6: Supply Voltage Tolerances= +0.1 ALL DIMENSIONS IN MILLIMETERS TAPE A B C D E 16±.3-.1 7.5±.1 6.75±.1 4 ±.1 2±.1 F G H J K 8±.1 B0* 1.5 +.1-0 A0* .3 ±.05 F M N O P Q 1.5 MIN 50 MIN 20.2 MIN 13±.2 40 MIN QTY/REEL 1,000 REEL L K0* R S T U V 2.5 MIN 10 MIN 22.4 MAX 360 MAX 16.4+2-0 *Compliant to EIA 481A ENVIRONMENTAL/MECHANICAL SPECIFICATIONS MARKING SPECIFICATIONS Line 1: ECLIPTEK Characteristic Specification Fine Leak Test Gross Leak Test Mechanical Shock Vibration Solderability Temperature Cycling Resistance to Soldering Heat Resistance to Solvents MIL-STD-883, Method 1014, Condition A MIL-STD-883, Method 1014, Condition C MIL-STD-202, Method 213, Condition C MIL-STD-883, Method 2007, Condition A MIL-STD-883, Method 2002 MIL-STD-883, Method 1010 MIL-STD-202, Method 210 MIL-STD-202, Method 215 Line 2: XX.XXX M Frequency in MHz (5 Digits Maximum + Decimal) Line 3: XX Y ZZ Week of Year Last Digit of Year Ecliptek Manufacturing Identifier MANUFACTURER CATEGORY SERIES PACKAGE VOLTAGE CLASS ECLIPTEK CORP. OSCILLATOR E15C7 CERAMIC 2.5V OS1C 800-ECLIPTEK www.ecliptek.com for latest revision REV.DATE 01/07 Specifications subject to change without notice.