EL15C7 Series EL15C7 • RoHS Compliant (Pb-Free) • LVDS Output Oscillators • 2.5V Supply Voltage • Ceramic 6-pad SMD Package • Stability to ±25ppm • Tri-State Output • Complementary Output • Available on Tape and Reel • Wide Range of Available Frequencies H L W 2.0 7.0 5.0 OSCILLATOR ELECTRICAL SPECIFICATIONS Nominal Frequency (MHz) 78.125M, 80M, 80.157M, 85M, 87.125M, 90M, 100M, 106.25M, 110M, 119M, 120M, 122.888M, 124.4M, 125M, 127M, 128M, 133M, 133.333M, 137.472M, 150M, 155.52M, 156.25M, 159.375M, 161.1328M , 162.5M, 166M, 170M, 175M, 176.83816M, 187.5M, 187.509375M, 200M, or 212.5MHz Operating Temperature Range Storage Temperature Range Supply Voltage (VCC) Input Current Frequency Tolerance / Stability Output Voltage Logic High (VOH) Output Voltage Logic Low (VOL) Differential Output Voltage (VOD) Offset Voltage (VOS) Rise Time / Fall Time Differential Output Error (DVDD) Duty Cycle Offset Error (DVOS) Output Swing (DVOPP) Load Drive Capability Logic Control / Additional Output Tri-State Input Voltage Standby Current Start Up Time RMS Phase Jitter Typical Phase Noise With Load Inclusive of All Conditions: Calibration Tolerance at 25°C, Frequency Stability over the Operating Temperature Range, Supply Voltage Change, Output Load Change, 1st Year Aging at 25°C, Shock, and Vibration 0°C to 70°C, or -40°C to +85°C -55°C to 125°C 2.5VDC ±5% 65mA Maximum ±100ppm, ±50ppm, or ±25ppm Maximum 1.43VDC Typical, 1.6VDC Maximum 1.1VDC Typical, 0.9VDC Minimum 247mV Minimum, 330mV Typical, 454mV Maximum 1.125V Minimum, 1.250V Typical, 1.375V Maximum 300pSec Typical, 700pSec Maximum 50mV Maximum 50 ±5(%) 150mV Maximum 250mVdc Minimum 100 Ohms Tri-State and Complementary Output Enables Outputs Enables Outputs Disables Outputs: High Impedance 30µA Maximum 10 mSeconds Maximum 0.4pSec Typical, 1 pSec Maximum -60dBc/Hz at 10Hz Offset -95dBc/Hz at 100Hz Offset -125dBc/Hz at 1kHz Offset -143dBc/Hz at 10kHz Offset -145dBc/Hz at 100kHz Offset 20% to 80% of waveform at 50% of waveform or at the crossing point Between Output and Complementary Output VIH of 70% of VCC Minimum No Connection VIL of 30% of VCC Maximum Without Load FJ = 12kHz to 20MHz Fo=156.250MHz -145dBc/Hz at 1MHz Offset -146dBc/Hz at 10MHz Offset MANUFACTURER CATEGORY ECLIPTEK CORP. OSCILLATOR SERIES EL15C7 800-ECLIPTEK www.ecliptek.com for latest revision PACKAGE VOLTAGE CLASS REV.DATE CERAMIC 2.5V OS5H 01/07 Specifications subject to change without notice. PART NUMBERING GUIDE EL15C7 E 2 F - 155.520M TR FREQUENCY TOLERANCE & STABILITY/ OPERATING TEMPERATURE RANGE C=±100ppm Maximum over 0°C to +70°C D=±50ppm Maximum over 0°C to +70°C E=±25ppm Maximum over 0°C to +70°C G=±100ppm Maximum over -40°C to +85°C H=±50ppm Maximum over -40°C to +85°C J=±25ppm Maximum over -40°C to +85°C (*) AVAILABLE OPTIONS Blank=Tubes TR=Tape and Reel (Standard) FREQUENCY LOGIC CONTROL/ADDITIONAL OUTPUT F=Tri-State and Complementary Output DUTY CYCLE 2=50 ±5(%) (*) Not available over Nominal Frequency range of 176.83816MHz to 212.500MHz MECHANICAL DIMENSIONS SUGGESTED SOLDER PAD LAYOUT ALL DIMENSIONS IN MILLIMETERS ALL DIMENSIONS IN MILLIMETERS 5.00 ±0.20 2.00 MAX 2.60 +0.40/-0.60 MARKINING ORIENTATION 2.54 ±0.10 7.00 +0.70/ 5.08 -0.15 ±0.20 6 1 5 2 4 Pin 1: Tri-State Pin 2: No Connect Pin 3: Case Ground 1.2 +0.3/ -0.2 1.4 ±0.2 3 Pin 4: Output Pin 5: Complementary Output Pin 6: Supply Voltage Tolerances= +0.1 TAPE AND REEL DIMENSIONS ALL DIMENSIONS IN MILLIMETERS TAPE A B C D E 16±.3-.1 7.5±.1 6.75±.1 4 ±.1 2±.1 F G H J K 8±.1 B0* 1.5 +.1-0 A0* .3 ±.05 F M N O P Q 1.5 MIN 50 MIN 20.2 MIN 13±.2 40 MIN QTY/REEL 1,000 REEL L K0* R S T U V 2.5 MIN 10 MIN 22.4 MAX 360 MAX 16.4+2-0 *Compliant to EIA 481A ENVIRONMENTAL/MECHANICAL SPECIFICATIONS MARKING SPECIFICATIONS Line 1: ECLIPTEK Characteristic Specification Fine Leak Test Gross Leak Test Mechanical Shock Vibration Solderability Temperature Cycling Resistance to Soldering Heat Resistance to Solvents MIL-STD-883, Method 1014, Condition A MIL-STD-883, Method 1014, Condition C MIL-STD-202, Method 213, Condition C MIL-STD-883, Method 2007, Condition A MIL-STD-883, Method 2002 MIL-STD-883, Method 1010 MIL-STD-202, Method 210 MIL-STD-202, Method 215 MANUFACTURER CATEGORY ECLIPTEK CORP. OSCILLATOR SERIES EL15C7 800-ECLIPTEK www.ecliptek.com for latest revision Line 2: XX.XXX M Frequency in MHz (5 Digits Maximum + Decimal) Line 3: XX Y ZZ Week of Year Last Digit of Year Ecliptek Manufacturing Identifier PACKAGE VOLTAGE CLASS CERAMIC 3.3V OS5H REV.DATE 01/07 Specifications subject to change without notice.