THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 581-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS ABSOLUTE MAXIMUM RATINGS PARAMETER Storage Temperature TABLE 1.0 UNITS MINIMUM -40 NOMINAL - MAXIMUM 85 UNITS °C (Vcc) -0.5 - 7 Vdc MINIMUM 1.8 -25 0 NOMINAL - MAXIMUM 170 25 70 UNITS MHz ppm °C Supply Voltage OPERATING SPECIFICATIONS NOTE CW 0107 FSHD51E 125.00M SURFACE MOUNT HCMOS CLOCK FSHD51E TABLE 2.0 PARAMETER Frequency Range Total Frequency Tolerance Operating Temperature Range (Fo) NOTE 1 The Connor-Winfield FSHD51E is a 5.0V, surface mount, Crystal Controlled Oscillator (XO) HCMOS / TTL Compatible. The FSHD51E is designed for applications requiring high frequency, low jitter and tight frequency stability. Supply Voltage (Vcc) 4.50 5.00 5.50 Vdc Supply Current (Icc) (Icc) (Icc) (Icc) - - 40 50 80 90 5 1 mA mA mA mA ps rms ps rms SSB Phase Noise at 10Hz offset - -60 - dBc/Hz SSB Phase Noise at 100Hz offset - -90 - dBc/Hz SSB Phase Noise at 1KHz offset - -125 - dBc/Hz SSB Phase Noise at 10KHz offset - -135 - dBc/Hz SSB Phase Noise at 100KHz offset - -140 - dBc/Hz MINIMUM NOMINAL MAXIMUM UNITS NOTE 2 2 1.8 to 31.999 MHz 32 to 66.999 MHz 67 to 124.999 MHz 125 to 170 MHz Jitter (BW=10Hz to 20MHz) Jitter (BW=12kHz to 20MHz) INPUT CHARACTERISTICS DESCRIPTION TABLE 3.0 PARAMETER Tri-state Enable Voltage (Vih) >70%Vcc - - Vdc Tri-state Disable Voltage (Vil) - - <30%Vcc Vdc FEATURES 5.0V OPERATION HCMOS OUTPUT CHARACTERISTICS PARAMETER LOAD Voltage (High) (Low) Current TABLE 4.0 (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% PACKAGE CHARACTERISTICS Package (Voh) (Vol) MINIMUM > 0.9(Vcc) - NOMINAL - MAXIMUM 50 < 0.1(Vcc) UNITS pF Vdc Vdc (Ioh) -16 - - mA (Ioh) 45 - 50 3 16 55 5 mA % nS FREQUENCY TOLERANCE ±25ppm NOTE TEMPERATURE RANGE: 0 to 70°C LOW JITTER <1pS RMS TRI-STATE ENABLE/DISABLE SURFACE MOUNT PACKAGE TAPE AND REEL PACKAGING TABLE 5.0 Non-hermetic package consisting of an FR4 substrate with grounded metal cover. PROCESS RECOMMENDATIONS TABLE 6.0 The component solder used internal to this device has a m elting point of 221°C. The peak temperature inside the device should be less than or equal to 220°C for a maximum of 10 seconds Ultrasonic cleaning is not recommended. Solder Reflow Wash Note: 1) Inclusive of calibration, frequency vs. temperature stability, supply voltage change, load change, shock and vibration, 20 years aging. 2) Oscillator output is enabled with no connection on pad 1 ORDERING INFORMATION FSHD51E CLOCK SERIES - 125.00 MHz CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: INT Hc188 PAGE 1 OF 2 REV: 00 DATE: 8/7/02 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 581-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS .130 MAX CW DATE CODE FSHD51E 125.00M (3.302mm) ENABLE/DISABLE GROUND OUTPUT Vcc Dimensional Tolerance: ±.005 (.127mm) E/D Specifications subject to change without notice. DATA SHEET #: INT Hc188 PAGE 2 OF 2 REV: 00 DATE: 8/7/02 aCopyright 2001 Connor-Winfield all rights reserved.