THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. HTTP://WWW.CONWIN.COM PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS CW 0107 FPHA552 155.52M SURFACE MOUNT 5.0V PECL CLOCK ABSOLUTE MAXIMUM RATINGS FPHA552 TABLE 1.0 PARAMETER UNITS Storage Temperature Supply Voltage (Vcc) MINIMUM NOMINAL MAXIMUM UNITS -40 - 85 °C -0.5 - 7.0 Vdc OPERATING SPECIFICATIONS NOTE DESCRIPTION TABLE 2.0 PARAME TER MINIMUM NOMINAL MAXIMUM UNITS NOTE 44.736 -15 0 - MHz ppm °C 1 - 200 15 70 (Vcc) 4.75 5.0 5.25 Vdc (Icc) - - 70 mA Jitter (BW=10Hz to 20MHz) - - 5 pS RMS Jitter (BW=12kHz to 20MHz) - - 1 pS RMS SSB Phase Noise at 10Hz offset - -60 - dBc/Hz SSB Phase Noise at 100Hz offset - -90 - dBc/Hz SSB Phase Noise at 1KHz offset - -100 - dBc/Hz SSB Phase Noise at 10KHz offset - -125 - dBc/Hz SSB Phase Noise at 10KHz offset - -135 - dBc/Hz MINIMUM NOMINAL MAXIMUM UNITS NOTE - - Vdc 2 3.40 Vdc 2 Center Frequency Total Frequency Tolerance Operating Temperature Range (Fo) Supply Voltage Supply Current INPUT CHARACTERISTICS The Connor-Winfield FPHA552 is a fixed frequency surface mount Crystal Controlled Oscillator (XO) designed for applications requiring low jitter and tight frequency stability. Operating at 5.0V supply voltage, the FPHA552 provides a PECL compatible output with an enable/disable function. TABLE 3.0 PARAMETER Disable Input Voltage (High) (Vih) 3.96 Enable Input Voltage (Low) (Vil) - PECL OUTPUT CHARACTERISTICS PARAMETER LOAD Voltage (High) (Low) Duty Cycle Rise / Fall Time 20% to 80% TABLE 4.0 MINIMUM 3.96 45 - (Voh) (Vol) PACKAGE CHARACTERISTICS Package NOMINAL 50 - MAXIMUM 50 3.40 55 1 UNITS Ohms Vdc Vdc % nS NOTE 3 4 FEATURES 5.0V OPERATION ENABLE/DISABLE LOW JITTER <1ps RMS OVERALL FREQUENCY TOLERANCE: ±15ppm TEMPERATURE RANGE: 0 to 70°C SINGLE-ENDED PECL OUTPUT TABLE 5.0 Non-hermetic package consisting of an FR4 subs trate with grounded metal cover. SURFACE MOUNT PACKAGE TAPE AND REEL PACKAGING PROCESS RECOMMENDATIONS Solder Reflow Wash TABLE 6.0 The component solder used internal to this device has a melting point of 221°C. The peak temperature inside the device should be less than or equal to 220°C for a maximum of 10 seconds Ultrasonic cleaning is not recommended. Notes 1) Includes initial tolerance, deviation over t emperature, supply and load variations, shock, vibrati on and 10 years aging. 2) When the oscillator is disabled, t he true output is in a low state (Vol). 3) Output must be terminated into 50 ohms to Vcc – 2V or Thevenin equivalent. 4) Duty Cycle measured at 3.67V ORDERING INFORMATION FPHA552 - 155.52MHz ECL SERIES DATA SHEET #: EC203 PAGE 1 OF 2 REV: 01 DATE: 01/21/05 CENTER FREQUENCY Specifications subject to change without notice. aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. HTTP://WWW.CONWIN.COM PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS CW DATE CODE FPHA552 155.52M Pin 1 2 3 4 5 6 7 8 9 10 Connection N/C Enable / Disable N/C Ground N/C N/C Q Output N/C Vcc N/C SUGGESTED PAD LAYOUT OUTPUT WAVEFORM TEST CIRCUIT DATA SHEET #: EC203 PAGE 2 OF 2 REV: 01 DATE: 01/21/05 Specifications subject to change without notice. aCopyright 2001 Connor-Winfield all rights reserved.