Approved by: Checked by: Issued by: SPECIFICATION PRODUCT: SAW FILTER MODEL: HB3601D （X6857D） SIP5D HOPE MICROELECTRONICS CO.,LIMITED Tel:+86-755-82973806 Fax:+86-755-82973550 E-mail: [email protected] http://www.hoperf.com Page 1 of 1 1.Construction 1.1 Dimension and materials Type : B3601D 1.2. Circuit construction, measurement circuit 2.Characteristics Standard atmospheric conditions Unless otherwise specified , the standard rang of atmospheric conditions for making measurements and tests is as follows; Ambient temperature : 15℃ to 35℃ Relative humidity : 25% to 85% Air pressure : 86kPa to 106kPa 1 Operating temperature rang Operating temperature rang is the rang of ambient temperatures in which the filter can be operated continuously. -10℃ ~ +60℃ Storage temperature rang Storage temperature rang is the rang of ambient temperatures at which the filter can be stored without damage. Conditions are as specified elsewhere in these specifications. -40℃ ~ +70℃ Reference temperature +25℃ 2.1 Maximum Rating DC voltage VDC 12 V AC voltage Vpp 10 V 2.2 Electrical Characteristics Source impedance Zs=50Ω Load impedance ZL=2kΩ//3pF Item Freq min Center frequency Fo Insertion attenuation 36.00MHz 19.0 Reference level B1.5dB B3dB Pass bandwidth B15dB B30dB 31.65MHz 7.0 40.35MHz 7.0 Relative attenuation 31.30MHz 22.0 40.70MHz 22.0 25.00~31.00MHz 32.0 Sidelobe 41.00~45.00MHz 30.0 Temperature coefficient Between any terminals Between any terminals TA=25℃ typ 36.00 max - MHz 21.0 23.0 dB 7.8 8.1 8.9 9.4 10.0 10.0 29.0 29.0 40.0 38.0 -72 - MHz MHz MHz MHz dB dB dB dB dB dB ppm/k 2.3 Environmental Performance Characteristics Item Test condition Allowable change of absolute Level at center frequency(dB) High temperature test < 1.0 70℃ 1000H Low temperature test < 1.0 -40℃ 1000H Humidity test < 1.0 40℃ 90-95% 1000H Thermal shock < 1.0 2 -20℃==25℃==80℃ 20 cycle 30M 10M 30M Solder temperature test Sold temp.260℃ for 10 sec. Soldering Immerse the pins melt solder at 260℃+5/-0℃ for 5 sec. 2.4 Mechanical Test Item Test condition Vibration test 600-3300rpm amplitude 1.5mm 3 directions 2 H each Drop test On maple plate from 1 m high 3 times Lead pull test Pull with 1 kg force for 30 seconds Lead bend test 90o bending with 500g weigh 2 times 2.5 Voltage Discharge Test Item Test condition Surge test Between any two electrode < 1.0 More then 95% of total area of the pins should be covered with solder Allowable change of absolute Level at center frequency(dB) <1.0 <1.0 <1.0 <1.0 Allowable change of absolute Level at center frequency(dB) <1.0 3 2.6 Frequency response： 4