LU97—AC-Link Soft Modem Chip Set FEATURES ■ Operating system support: — Windows1 95, 98, 2000 — PC ‘99 compliant — ACPI compliant ■ High-speed data mode capabilities: — ITU-T V.90 data rates 28000 bits/s— 56000 bits/s2 — Ultrahigh compression throughput due to parallel access directly to the host PC — ITU-T V.34 extended rates: 33600 bits/s— 2400 bits/s V.32terbo, V.32bis, and fallbacks — TIA/EIA 602 standard for AT command set — V.42 error correction (LAPM and MNP3) — V.42bis and MNP Class 5 data compression ■ FAX mode capabilities: — ITU-T V.17, V.29, V.27ter, and V.21 Ch 2 — TIA/EIA4 578 Class 1 FAX ■ Video-ready modem interface (VRM) V.80 ■ Complete DAA includes the following: — AC‘97/MC‘97 2.1 compliant — International line interface — Compliant with FCC, CTR21, JATE, and other PTTs — 3.3 V to 5 V power supply — 2400 V isolation — Integrated ring detector — Integrated analog front end (AFE) — 2-wire to 4-wire hybrid — Low-power standby mode — Low-profile SOIC packages ■ Applications: — Modem riser cards — Mobile daughter cards 1. 2. Windows is a registered trademark of Microsoft Corporation. Actual speeds over U.S. telephone lines vary and are less than 56K, due to current FCC regulations and line conditions. MNP is a registered trademark of Microcom, Inc. EIA is a registered trademark of Electronic Industries Association. 3. 4. INTRODUCTION The LU97 chip set is an integrated direct access arrangement (DAA) that provides a programmable line interface to meet international telephone line requirements. The LU97 chip set is available in two 16-pin small outline packages (AC‘97 interface on CSP1037 and telephone line interface on CSP1037A/B). The chip set eliminates the need for an AFE, an isolation transformer, relays, opto-isolators, and a 2-wire to 4-wire hybrid. The LU97 chip set dramatically reduces the number of discrete components and cost required to achieve compliance with international regulatory requirements. The CSP1037 complies with AC‘97/MC‘97 Interface Specification Rev. 2.1. FUNCTIONAL DESCRIPTION The LU97 chip set is an integrated chip set that provides a low-cost, isolated, silicon-based MC‘97 compliant interface to the telephone line. The chip set saves cost and board area by eliminating the need for a modem AFE or serial codec. It also eliminates the need for an isolation transformer, relays, opto-isolators, and a 2-wire to 4-wire hybrid. The LU97 chip set complies with AC‘97/MC‘97 Interface Specification Rev. 2.1. The chip set is fully programmable to meet worldwide telephone line interface requirements, including those described by CTR21, JATE, FCC, and various country-specific PTT specifications. The programmable parameters of the LU97 chip set include ac termination, dc termination, ringer impedance, and ringer threshold. The LU97 chip set has been designed to meet stringent worldwide requirements for out-of-band energy, billing-tone immunity, lightning surges, and safety requirements. CSP 1037 CSP 1037A/B XOUT MCLK/XIN RX CLOCK FILT HYBIRD AND dc TERMINATION RESET BIT_CLK SYNC AC’97 DIGITAL INTERFACE SDATA_IN ISOLATION INTERFACE ISOLATION INTERFACE FILT2 REF DCT VREG VREG2 REXT SDATA_ OUT REXT2 ID0 RING DETECT ID1 RNG1 RNG2 CONTROL INTERFACE QB GPIO_A QE OFF-HOOK GPIO_B QE2 Figure 1. Functional Block Diagram For additional information, contact your Microelectronics Group Account Manager or the following INTERNET: http://www.lucent.com/micro E-MAIL: [email protected] N. AMERICA: Microelectronics, Lucent Technologies Inc., 555 Union Boulevard, Room 30L-15P-BA, Allentown, PA 18103 1-800-372-2447, FAX 610-712-4106 (In Canada: 1-800-553-2448, FAX 610-712-4106) ASIA PACIFIC: Microelectronics Asia/Pacific, Lucent Technologies Inc., 77 Science Park Drive, #03-18 Cintech III, Singapore 118256 Tel. (65) 778-8833, FAX (65) 777-7495 CHINA: Microelectronics Group, Lucent Technologies (China) Co., Ltd., A-F2, 23/F, Zao Fong Universe Building, 1800 Zhong Shan Xi Road, Shanghai 200233 P. R. China Tel. (86) 21 6440 0468, ext. 316, FAX (86) 21 6440 0652 JAPAN: Microelectronics, Lucent Technologies Japan Ltd., 7-18, Higashi-Gotanda 2-chome, Shinagawa-ku, Tokyo 141, Japan Tel. (81) 3-5421-1600, FAX (81) 3-5421-1700 EUROPE: For data requests: Microelectronics Group Dataline: Tel. (44) 7000 582 368, FAX (44) 1189 328 148 For technical inquiries: GERMANY: (49) 89 95086 0 (Munich), UNITED KINGDOM: (44) 1344 865 900 (Ascot), FRANCE: (33) 1 40 83 68 00 (Paris), SWEDEN: (46) 8 594 607 00 (Stockholm), FINLAND: (358) 9 4354 2800 (Helsinki), ITALY: (39) 02 6608131 (Milan), SPAIN: (34) 1 807 1441 (Madrid) Lucent Technologies Inc. reserves the right to make changes to the product(s) or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Copyright © 1999 Lucent Technologies Inc. All Rights Reserved Printed in U.S.A. November 1999 OT00-112DMOD Printed On Recycled Paper