Series X55X High-Temperature Universal Zero-Insertion-Force DIP Test Socket FEATURES • Universal Test Socket accepts devices on 0.300 to 0.600 [7.62 to 15.24] centers •All pin count sockets go into PCB with either 0.300 or 0.600 [7.62 or 15.24] centers •Contacts are normally closed to eliminate dependence on plastic to sustain contact •Socket handle can be configured with closed contacts (on) when in the UP or DOWN position, and can be mounted on either the right or left side •Sockets can be soldered into PCBs. Socket fits into Aries Test Socket Receptacle on Data Sheet 10003 GENERAL SPECIFICATIONS •SOCKET BODY: natural UL 94V-0 glass-filled Polyetheretherketone (PEEK) •HANDLE: Stainless Steel CUSTOMIZATION: In addition to the standard products shown •CONTACTS: BeNi 360, 1/2-hard on this page, Aries specializes in custom design and production. •CONTACT PLATING: 50μ [1.27μ] NiB Special materials, platings, sizes, and configurations can be furnished, depending on the quantity. NOTE: Aries reserves the •CONTACT CURRENT RATING: 1 amp right to change product general specifications without notice. • OPERATING TEMPERATURE: -67°F [-55°C] min.; 482°F [250°C] max. • RETENTION FORCE (closed): 55g/pin based on a 0.020 [0.51] dia. test lead • INSULATION RESISTANCE: 1000 mΩ min. ORDERING INFORMATION • DIELECTRIC WITHSTANDING VOLTAGE: 1000 VAC XX-X55X-1 8 • LIFE CYCLE: 25,000 to 50,000 cycles Pins NiB (Spinodal) Plating • ACCEPTS LEADS: 0.015-0.045 [0.38-1.14] wide, 24, 28, 32, 36, Solder Pin Tail 0.110-0.280 [2.79-7.11] long 40, 42, 44, 48 Handle Options MOUNTING CONSIDERATIONS Row-to-Row Spacing (btm) 1 = Left, up is on •See Socket Footprint below 3 = 0.300 [7.62] 2 = Right, up is on 6 = 0.600 [15.24] (std) 3 = Left, down is on 4 = Right, down is on (std) NOTE: ‘on’ = closed contacts ALL DIMENSIONS: INCHES [MILLIMETERS] ALL TOLERANCES: ±0.005 [0.13] UNLESS OTHERWISE SPECIFIED “A” = (NO. OF PINS PER ROW x 0.100 [2.54]) + 0.590 [14.99] “B” = (NO. OF PINS PER ROW -1) x 0.100 [2.54] “C” = (NO. OF PINS PER ROW x 0.100 [2.54] + 0.415 [10.54] DO NOT USE THESE SOCKETS IN A BURN-IN OVEN WITH THE SOCKET CONTACTS IN THE OPEN POSITION, AS IT WILL DAMAGE THE SOCKET. CONSULT FACTORY FOR OTHER SIZES AND CONFIGURATIONS Bristol, PA 19007-6810 USA TEL (215) 781-9956 • FAX (215) 781-9845 WWW.ARIESELEC.COM • [email protected] PRINTOUTS OF THIS DOCUMENT MAY BE OUT OF DATE AND SHOULD BE CONSIDERED UNCONTROLLED 10002 Rev. AA