MH101 The Communications Edge ™ Product Information High Dynamic Range MMIC Mixer Product Features Product Description • +30 dBm Input IP3 • No External Matching Elements Required • RF 1900-2200 MHz • LO 1700-2150 MHz • IF 50-200 MHz • +17 dBm Drive Level • Low Cost SOIC-8 Package • No External Bias Required Functional Diagram The MH101 is a passive GaAs MESFET mixer that provides high dynamic range performance in a low cost SOIC-8 package. WJ’s MH101 uses patented techniques to realize greater than +30 dBm Input IP3 at an LO drive level of +17 dBm. This single monolithic integrated circuit does not require any external baluns, bias, matching, or decoupling elements. The on-chip diplexer affords good matching on the RF and IF ports. Typical applications include frequency up/down conversion, modulation and demodulation for receivers and transmitters used in 3G UMTS systems. 4 3 2 1 5 6 7 8 Function RF LO IF Ground Pin No. 7 2 5 1,3,4,6,8 Specifications Parameter Frequency Range: RF LO IF SSB Conversion Loss Noise Figure Input IP3 Input P1dB Isolation: L-R L-I R-I Return Loss: RF Port LO Port IF Port LO Drive Level Units Minimum MHz MHz MHz dB dB dBm dBm 1900 1700 50 dB dB dB 21 27 12 +28 dB dB dB dBm Typical 9.0 9.5 +30 +16 Maximum Condition 2200 2150 200 10.5 28 37 18 15 12 20 +17 Test conditions unless otherwise noted: RF / IF = 1900 / 50, 1900 / 200, 2200 / 50 and 2200 / 200 MHz with a low-side LO at +17 dBm in a downconverting application at 25°C. Input IP3 was measured with two tones with an input power of +2 dBm/tone separated by 10 MHz. Absolute Maximum Ratings1 Parameter Operating Case Temperature Storage Temperature Maximum Input LO Power2 Ordering Information Rating Part No. Description -40 to +85°C -65 to +100°C +21 dBm MH101 High Dynamic Range MMIC Mixer (Available in tape and reel) Fully Assembled Application Circuit MH101-PCB 1. Operation of this device above any of these parameters may cause permanent damage. 2. Total sum of LO port and RF port power should not to exceed +23 dBm. Specifications and information are subject to change without notice. WJ Communications, Inc. • Phone: 1-800-WJ1-4401 • FAX: 408-577-6620 • e-mail: [email protected] • Web site: www.wj.com February 2004 MH101 The Communications Edge ™ Product Information High Dynamic Range MMIC Mixer Performance Charts IF = 200 MHz IF = 150 MHz IF = 100 MHz IF = 50 MHz 27 26 2000 2050 2100 RF Frequency (MHz) 2150 8.4 2200 IF Return Loss vs IF Frequency 1900 1950 2000 2050 2100 RF Frequency (MHz) 2150 10 15 20 175 200 225 250 IF Frequency (MHz) 275 300 5 IF = 100 MHz 10 15 20 25 1900 1950 2000 2050 2100 RF Frequency (MHz) 2150 L-I 35 30 L-R 20 1700 1750 1800 1850 1900 1950 2000 2050 2100 2150 LO Frequency (MHz) 2200 RF Return Loss vs RF Frequency RF = 2000 MHz 40 25 0 0 RF Return Loss (dB) IF Return Loss (dB) IF = 100 MHz IF = 50 MHz 8.6 0 25 150 45 8.8 8.2 1950 IF = 200 MHz IF = 150 MHz 9.0 LO Return Loss (dB) 25 1900 50 Isolation (dB) 31 30 29 28 5 Isolation vs LO Frequency Conversion Loss vs RF Frequency 9.2 Conversion Loss (dB) Input Intercept Point (dBm) Input IP3 vs RF Frequency 35 34 33 32 2200 LO Return Loss vs LO Frequency 5 10 15 20 25 30 1700 1750 1800 1850 1900 1950 2050 2100 2150 2200 LO Frequency (MHz) Data was taken using the application board in a 50 W system, with a low side LO at +17 dBm in a downconvertering applicaion at 25°C. Input IP3 was measured with two tones with an input power of +5 dBm/tone separated by 1 MHz. Application Circuit IF RF LO Specifications and information are subject to change without notice. WJ Communications, Inc. • Phone: 1-800-WJ1-4401 • FAX: 408-577-6620 • e-mail: [email protected] • Web site: www.wj.com February 2004 MH101 The Communications Edge ™ Product Information High Dynamic Range MMIC Mixer MSL / ESD Rating MH101 XXXX-X Outline Drawing Land Pattern 'MH101' = Part Designation 'XXXX-X' = Lot Code ESD Rating: Value: Test: Standard: Class 0 Passes between 150V and 200V Human Body Model (HBM) JEDEC Standard JESD22-A114 ESD Rating: Value: Test: Standard: Class II Passes between 250V and 500V Charged Device Model (CDM) JEDEC Standard JESD22-C101 MSL Rating: Level 3 Standard: JEDEC Standard J-STD-020A Mounting Configuration Specifications and information are subject to change without notice. WJ Communications, Inc. • Phone: 1-800-WJ1-4401 • FAX: 408-577-6620 • e-mail: [email protected] • Web site: www.wj.com February 2004