NTE7144 Integrated Circuit BIMOS Operational Amplifier w/MOSFET Input, Bipolar Output Description: The NTE7144 is an integrated circuit operational amplifier in an 8–Lead Mini–DIP type package that combines the advantages of high–voltage PMOS transistors with high–voltage bipolar transistors on a single monolithic chip. This device features gate–protected MOSFET (PMOS) transistors in the input circuit to provide very–high–input impedance, very–low–input current, and high–speed performance. The NTE7144 operates at supply voltages from 4V to 36V (either single or dual supply) and is internally phase–compensated to achieve stable operation in unity–gain follower operation. The use of PMOS field–effect transistors in the input stage results in common–mode input–voltage capability down to 0.5V below the negative–supply terminal, an important attribute for single–supply applications. The output stage uses bipolar transistors and includes built–in protection against damage from load–terminal short–circuiting to either supply–rail or to GND. Features: D MOSFET Input Stage: Very High Input Impedance Very Low Input Current Wide Common–Mode Input Voltage Range Output Swing Complements Input Common–Mode Range D Directly Replaces Industry Type 741 in Most Applications Applications: D Ground–Referenced Single–Supply Amplifiers in Automobile and Portable Instrumentation D Sample and Hold Amplifiers D Long–Duration Timers/Multivibrators (Microseconds – Minutes – Hours) D Photocurrent Instrumentation D Peak Detectors D Active Filters D Comparators D Interface in 5V TTL Systems and other Low–Supply Voltage Systems D All Standard Operational Amplifier Applications D Function Generators D Tone Controls D Power Supplies D Portable Instruments D Intrusion Alarm Systems Absolute Maximum Ratings: DC Supply Voltage (Between V+ and V– Terminals) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36V Differential–Mode Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±8V Common–Mode DC Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (V+ +8V) to (V– –0.5V) Input–Terminal Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1mA Device Dissipation (Without Heatsink), PD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 630mW Derate Linearly Above +55°C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.67mW/°C Device Dissipation (With Heatsink), PD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1W Derate Linearly Above +55°C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16.7mW/°C Operating Temperature Range, Topr . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –55° to +125°C Storage Temperature Range, Tstg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –65° to +150°C Lead Temperature (During Soldering, 1/16” from case, 10sec max), TL . . . . . . . . . . . . . . . . . +265°C Output Short–Circuit Duration (Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Unlimited Note 1. Short circuit may be applied to GND or to either supply. Electrical Characteristics: (TA = +25°C, V+ = +15V, V– = –15V unless otherwise specified) Parameter Symbol Test Conditions Min Typ Max Unit Input Offset Voltage |VIO| – 2 5 mV Input Offset Current |IIO| – 0.5 20 pA II – 10 40 pA 20k 100k – V/V 86 100 – dB – 32 320 µV/V 70 90 – dB Input Current Large–Signal Voltage Gain Common–Mode Rejection Ratio AOL Note 2 CMRR Common–Mode Input–Voltage Range VICR –15 –15.5 to +12.5 +12 V Power Supply Rejection Ratio ∆VIO/∆V – 100 150 µV/V PSSR 76 80 – dB +12 +13 – V VOM– –14 –14.4 – V Supply Current I+ – 4 6 mA Device Dissipation PD – 120 180 mW ∆VIO/∆T – 6 – µA/°C Input Resistance RI – 1.5 – TΩ Input Capacitance CI – 4 – pF Output Resistance RO – 60 – Ω Equivalent Wideband Input Noise Voltage en BW = 140kHz, RS = 1MΩ – 48 – µV Equivalent Input Noise Voltage en RS = 100Ω f – 1kHz – 40 – nV/√Hz f = 10kHz – 12 – nV/√Hz IOM+ – 40 – mA IOM– – 18 – mA Maximum Output Voltage Input Offset Voltage Temp. Drift Short–Circuit Current to Opposite Supply Source Sink VOM+ RL = 2kΩ Note 2. VO = 26VP–P, +12V, –14V and RL = 2kΩ. Electrical Characteristics (Cont’d): (TA = +25°C, V+ = +15V, V– = –15V unless otherwise specified) Parameter Symbol Test Conditions Min Typ Max Unit Gain–Bandwidth Product fT – 4.5 – MHz Slew Rate SR – 9 – V/µs – 220 – µA – 0.08 – µs – 10 – % – 4.5 – µs – 1.4 – µs Sink Current from Pin8 to Pin4 to Swing Output Low Transient Response: Rise Time tr RL = 2kΩ, CL = 100pF Overshoot Setting Time at 10VP–P 1mV ts 10mV RL = 2kΩ, CL = 100pF, Voltage Follower Note 2. VO = 26VP–P, +12V, –14V and RL = 2kΩ. Electrical Characteristics: (TA = +25°C, V+ = +5V, V– = –5V unless otherwise specified) Input Offset Voltage |VIO| – 2 – mV Input Offset Current |IIO| – 0.1 – pA Input Current II – 2 – pA Input Resistance RI – 1 – TΩ AOL – 100k – V/V – 100 – dB – 32 – µV/V – 90 – dB – –0.5 – V – +2.6 – V ∆VIO/∆V – 100 – µV/V PSSR – 80 – dB VOM+ – 3.0 – V VOM– – 0.13 – V IOM+ – 10 – mA IOM– – 1 – mA Slew Rate SR – 7 – V/µs Gain–Bandwidth Product fT – 3.7 – MHz Supply Current I+ – 1.6 – mA Device Dissipation PD – 8 – mW – 200 – µA Large–Signal Voltage Gain Common–Mode Rejection Ratio Common–Mode Input–Voltage Range Power Supply Rejection Ratio Maximum Output Voltage Maximum Output Current: Source Sink Sink Current from Pin8 to Pin4 to Swing Output Low CMRR VICR Pin Connection Diagram Offset Null 1 8 Strobe Invert Input 2 Non–Invert Input 3 7 V+ 6 Output V– 4 8 5 Offset Null 5 .260 (6.6) 1 4 .390 (9.9) Max .300 (7.62) .155 (3.93) .100 (2.54) .145 (3.68) .300 (7.62)