Photo IC PNA4611M Series (PNA4611M/4612M/4613M/4614M/4620M) Bipolar Integrated Circuit with Photodetection Function For infrared remote control systems Unit : mm External parts not required 5˚ R2.25±0.1 5˚ 2.0±0.1 3-1.5±0.2 22.0 min. Supports various metal holders with improved electromagnetic noise resistance 2.3 0.8 Resin to cutoff visible light is used 5˚ High sensitivity (extension distance is 11 m or more) 2.25 5˚ 8.0±0.2 5.2 Features 5.25±0.3 Not soldered 1.5 7.0±0.2 3.5 1.0±0.1 3-0.5 +0.2 –0.15 0.45±0.2 Absolute Maximum Ratings (Ta = 25˚C) Parameter Symbol Ratings Unit VCC – 0.5 to +7 V Power dissipation PD 200 mW Operating ambient temperature Topr –20 to +75 ˚C Storage temperature Tstg – 40 to +100 ˚C Power supply voltage 1 2 3 2-2.54 1: VOUT 2: GND 3: VCC Main Characteristics (Ta = 25˚C VCC = 5V) Parameter Symbol Conditions min typ max Operating supply voltage VCC Current consumption ICC Note 3 Maximum reception distance Lmax Note 1 11 Low-level output voltage VOL Note 2 4.7 5.0 5.3 V 1.8 2.4 3.0 mA High-level output voltage VOH Note 3 Low-level pulse width TWL Note 1 High-level pulse width TWH Note 1 200 m 0.35 0.5 4.8 5.0 VCC V 200 400 600 µs 400 600 µs PNA4611M V 36.7 PNA4612M Carrier frequency PNA4613M 16 Unit 38.0 f0 40.0 PNA4614M 56.9 PNA4620M 33.3 kHz Note 1) Fig.1 burst wave, L=Lmax, 16 pulses Note 2) Fig.2 continuous wave, L ≤ Lmax Note 3) Light shut off condition Carrier wave : f0 400µs Carrier wave : f0 400µs Fig.1 Fig.2 1 Photo IC PNA4611M, PNA4612M, PNA4613M, PNA4614M, PNA4620M Type YA Unit : mm Type YB Unit : mm 7.6 7.6 2-2.54 2-2.54 Recommendation hole location of P.C.board 7.6 3.8 1: VO 2: GND 3: VCC Unit : mm 1 2 3 2-3.75 7.3 1.0 7.0 Unit : mm 1 2 3 (3.6) 6.5 2-2.54 2-2.54 Recommendation hole location of P.C.board 2-1.4 7.6 11.4 5.5 1.5 2.25 8.5 0.45 +0.25 –0.15 (9.6) (11.3) 8.5 (9.7) (6.9) 3.1 0.8 16 (13.75) 3.1 2.25 2-1.8×1.2 3-ø0.9 4.4 (5.9) 10.45 8.75 3-ø0.9 1: VO 2: GND 3: VCC (5.5) 7.8 Recommendation hole location of P.C.board 7.6 2.0 R1.0 0.45±0.2 1 2 3 3-0.5±0.2 2-2.54 2.35 Type XD 2-1.7×1.2 2.5 (6.8) 7.4 3.5 (2.1) 2.0 1.2 3-0.5 +0.25 –0.15 2-2.54 21.4 12.9 18.3 2.0 4.0 (4.0) 0.45+0.25 –0.15 1 2 3 5.9 12.7 9.6 2.0 1.2 4.9 3.5 (7.4) 1.0 Type XB 15.7 13.45 2.25 R1.0 8.5 2.25 2-2.4×1.4 Recommendation hole location of P.C.board 7.6 10.35 (8.1) 3-ø0.8 5.5 5 6.5 4.0 3-ø0.9 2-2.4×1.4 3.6 7.0 3.6 2.4 1.6 3.7±0.6 3.6 2.4 1.6 3-0.5 +0.25 –0.15 1.0 2-2.54 0.6 1: VO 2: GND 3: VCC 2-2.54 Type HB 0.8×2.2 4.4 1 2 3 8.8 4.85 10.08 5.55 1.45 2.0±0.1 1: VO 2: GND 3: VCC Unit : mm 2-2.2×1.2 0.45 3-ø0.9 2-2.54 0.9 1.3 3-0.5 +0.25 –0.15 2-2.54 (9.83) 0.45 +0.25 –0.15 (6.9) 2.9 1.6 0.93 3.7±0.6 2 3.2 2.9 2-2.0±0.1 2.1 6.4 (11.9) 9.97 1.2 7.7 8.7 (3.15) 5.4 Recommendation hole location of P.C.board 1: VO 2: GND 3: VCC Note :Tolerance unless otherwise specified is ±0.5. PNA4611M, PNA4612M, PNA4613M, PNA4614M, PNA4620M Photo IC Block Diagram VCC (20kΩ) AGC B.P.F demodulator PD integrator peak hold ,, ,,, constant voltage RL comparator VO ,, amplifier GND Panasonic Transmitter Specifications LED Transmission unit Standard reception unit 10kΩ 10V PNZ323B 10µF 20cm V out 10kΩ V out 55mV 10kΩ GND The light output of the LED transmission unit is adjusted so that the transmission output (V out) of the standard reception unit will be 55 mV when the transmission waveform (duty = 50%) is output from the LED transmission unit. Here, infrared sensitivity (SIR) of PNZ323B is 0.53 µA when emission illuminance (H) is 12.45 µW/ cm2. The maximum reception distance under these specifications is an assurance that TWH and TWL values will be within the tolerance ranges when 16 consecutive pulses of an optical output equivalent to the maximum reception distance are transmitted by the above transmission unit (The maximum reception distance is measured in the dark without external disturbance noise.) 3 PNA4611M, PNA4612M, PNA4613M, PNA4614M, PNA4620M L max — Ta 100 100 Relative sensitivity S (%) Relative reception distance L max (%) 120 80 60 40 B.P.F frequency characteristics (PNA4612M)* 80 60 40 20 20 0 – 20 VCC = 5V Transmitter : Standard LED Transmission unit used 0 20 40 Ambient temperature 60 80 100 0 33 * 0˚ 10˚ 70 60 50 40 30 20 Relative reception distance (%) 90 80 20˚ 30˚ 40˚ 50˚ 60˚ 70˚ 80˚ 90˚ 4 35 37 39 41 43 Carrier frequency (kHz) 100 80 60 40 20 Ta (˚C ) Directivity characteristics Spectral sensitivity characteristics 100 Relative sensitivity S (%) Photo IC The peaks for PNA4611M, PNA4613M, PNA4614M, and PNA4620M are all at f0. 0 600 700 800 900 Wavelength 1000 1100 1200 λ (nm) Request for your special attention and precautions in using the technical information and semiconductors described in this material (1) An export permit needs to be obtained from the competent authorities of the Japanese Government if any of the products or technologies described in this material and controlled under the "Foreign Exchange and Foreign Trade Law" is to be exported or taken out of Japan. (2) The technical information described in this material is limited to showing representative characteristics and applied circuit examples of the products. It does not constitute the warranting of industrial property, the granting of relative rights, or the granting of any license. (3) The products described in this material are intended to be used for standard applications or general electronic equipment (such as office equipment, communications equipment, measuring instruments and household appliances). Consult our sales staff in advance for information on the following applications: • Special applications (such as for airplanes, aerospace, automobiles, traffic control equipment, combustion equipment, life support systems and safety devices) in which exceptional quality and reliability are required, or if the failure or malfunction of the products may directly jeopardize life or harm the human body. • Any applications other than the standard applications intended. (4) The products and product specifications described in this material are subject to change without notice for reasons of modification and/or improvement. At the final stage of your design, purchasing, or use of the products, therefore, ask for the most up-to-date Product Standards in advance to make sure that the latest specifications satisfy your requirements. (5) When designing your equipment, comply with the guaranteed values, in particular those of maximum rating, the range of operating power supply voltage and heat radiation characteristics. Otherwise, we will not be liable for any defect which may arise later in your equipment. Even when the products are used within the guaranteed values, redundant design is recommended, so that such equipment may not violate relevant laws or regulations because of the function of our products. (6) When using products for which dry packing is required, observe the conditions (including shelf life and after-unpacking standby time) agreed upon when specification sheets are individually exchanged. (7) No part of this material may be reprinted or reproduced by any means without written permission from our company. Please read the following notes before using the datasheets A. These materials are intended as a reference to assist customers with the selection of Panasonic semiconductor products best suited to their applications. Due to modification or other reasons, any information contained in this material, such as available product types, technical data, and so on, is subject to change without notice. Customers are advised to contact our semiconductor sales office and obtain the latest information before starting precise technical research and/or purchasing activities. B. Panasonic is endeavoring to continually improve the quality and reliability of these materials but there is always the possibility that further rectifications will be required in the future. Therefore, Panasonic will not assume any liability for any damages arising from any errors etc. that may appear in this material. C. These materials are solely intended for a customer's individual use. Therefore, without the prior written approval of Panasonic, any other use such as reproducing, selling, or distributing this material to a third party, via the Internet or in any other way, is prohibited. 2001 MAR