140 MHz SAW Filter 7 MHz Bandwidth Part Number: SF0140BA03069S Integrated Circuit Systems, Inc. TYPICAL PERFORMANCE Horizontal: 3 MHz/div Vertical (from top): Magnitude 10,1 dB/div Phase Deviation 10 deg/div Group Delay Variation 200 ns/div SPECIFICATION Parameter Center Frequency (Fc) 1 Insertion Loss 1 dB Bandwidth 3 dB Bandwidth 36 dB Bandwidth Passband Ripple Phase Deviation from Linear2 Group Delay Variation2 Absolute Delay Substrate Temperature Coefficient of Frequency (Tc)3 Ambient Temperature System Source and Load Impedance Notes: Min 139.6 5.9 7.0 Typ 140 7.2 6.3 7.3 10.2 0.4 7 60 1.1 YZ LiNbO3 -90 25 50 Max 140.4 8.0 10.7 1 14 200 Units MHz dB MHz MHz MHz dB deg ns µs ppm/°C °C Ω 1. Average of lower & upper 3 dB frequencies. 2. Evaluated over 70% of the 3 dB bandwidth. 3. Typical change of filter frequency response with temperature is ∆f/fref = (T-Tref)*Tc ppm. ICS • SAW Products • 324 Clark Street, Worcester, MA 01606, USA • Phone 1-508-852-5400 • Fax 1-508-852-8456 www.icst.com Rev X4 19-Apr-2005 Page 1 of 2 140 MHz SAW Filter 7 MHz Bandwidth Part Number: SF0140BA03069S Integrated Circuit Systems, Inc. PACKAGE OUTLINE Units: mm Pin Configuration: Input: 11 Output: 5 Ground: 1,2,3,4,6,7,8,9,10,12 Component values in 50 Ω: Cs1 = 220 pF MATCHING CIRCUIT 11 (Minimum Q = 45) 5 Lp1 = 33 nH Lp2 = 33 nH Notes • Optimum component values may change depending on board layout. The values shown here are intended as a guide only. ISO 9001 Registered All specifications are believed to be accurate and reliable. However, ICS reserves the right to make changes without notice. © 2005 Integrated Circuit Systems, Inc. All rights reserved. ICS • SAW Products • 324 Clark Street, Worcester, MA 01606, USA • Phone 1-508-852-5400 • Fax 1-508-852-8456 www.icst.com Rev X4 19-Apr-2005 Page 2 of 2 C