96 MHz SAW Bandpass Filter 4.8 MHz bandwidth Part Number SF0096BA02394S Integrated Circuit Systems, Inc. TYPICAL PERFORMANCE Horizontal: 2.5 MHz/div Vertical (from top): Magnitude Magnitude Group Delay Deviation 10 1 50 dB/div dB/div ns/div SPECIFICATION Parameter 1 2 Center Frequency ( Fc) 3 Minimum Insertion Loss 1 dB Bandwidth 35 dB bandwidth Passband Variation (Fc +/- 2.4 MHz) 4 Group Delay Variation (Fc +/- 2.4 MHz) Change in Absolute Delay from unit to unit Absolute Delay Variation from -5˚C to 75˚C Input Return Loss (Fc +/- 1.92 MHz) Output return Loss (Fc +/- 1.92 MHz) Absolute Delay Rejection (40 to 87 MHz) (111 to 150 MHz) Source and Load Impedance Substrate Material Ambient Temperature Notes: Min. 95.90 Typ. 96.00 4.80 5.00 6.60 0.6 60 -10 Max. 96.10 25 6.80 0.8 80 10 10 10 10 2.00 43 43 3.00 46 46 50 LiTaO3 23 Units. MHz dB MHz MHz dB p-p ns p-p ns ns dB dB us dB dB Ω ºC 1. All specifications for a device matched to a 50 ohm system impedance. 2. Average of Lower and Upper 3 dB Frequencies. 3. All dB values are referenced to the insertion loss 4. A smoothing aperture of 0.125 MHz may be applied to this measurement. Rev X6 20-Apr-05 Page 1 of 2 Integrated Circuit Systems • Surface Acoustic Wave Products 324 Clark Street, Worcester, MA 01606, USA • Phone 508-852-5400 • Fax 508-852-8456 www.icst.com QF12/3 96 MHz SAW Bandpass Filter 4.8 MHz bandwidth Part Number SF0096BA02394S Integrated Circuit Systems, Inc. PACKAGE OUTLINE Units: mm Pad Configuration: Input: 1 Input Return: 10 Output: 6 Output Return: 5 Ground: 2,3,4,7,8,9 MATCHING CIRCUIT Typical component values: 1 6 10 5 Ls1 = 6.8 nH Lp1 = 56 nH Rp1 = 100 Ω Ls2 = 91 nH Cp2 = 47 pF Rp2 = 120 Ω (Minimum inductor Q = 40) Notes • Recommend use of 2% tolerance components. • Optimum values depend on board layout. Values intended as guide only. ISO 9001 Registered Rev X6 20-Apr-05 Page 2 of 2 Integrated Circuit Systems • Surface Acoustic Wave Products 324 Clark Street, Worcester, MA 01606, USA • Phone 508-852-5400 • Fax 508-852-8456 www.icst.com QF12/3