Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: [email protected] Web: http://www.frontierusa.com 5A GLASS PASSIVATED SUPER FAST RECOVERY RECTIFIER SF50-005G THRU SF50-06G FEATURES z LOW POWER LOSS, HIGH EFFICIENCY z LOW FORWARD VOLTAGE z HIGH CURRENT CAPABILITY z HIGH SPEED SWITCHING z HIGH RELIABILITY z HIGH SURGE CAPABILITY z GLASS PASSIVATED CHIP JUNCTION 1.0(25.4) MIN .052(1.3) .048(1.2) .375(9.5) .335(8.5) MECHANICAL DATA z CASE: MOLDED PLASTIC, DO201AD, DIMENSIONS IN INCHES AND (MILLIMETERS) z EPOXY: UL 94V-0 MOLDING COMPOUND z LEADS: MIL-STD-202E, METHOD 208C GUARANTEED z MOUNTING POSITION: ANY z WEIGHT: 1.2 GRAMS .220(5.6) .197(5.0) 1.0(25.4) MIN MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS RATINGS AT 25°C AMBIENT TEMPERATURE UNLESS OTHERWISE SPECIFIED SINGLE PHASE, HALF WAVE, 60 HZ, RESISTIVE OR INDUCTIVE LOAD. FOR CAPACITIVE LOAD, DERATE CURRENT BY 20% SF50 SF50 SF50 SF50 SF50 SF50 SF50 SF50 UNITS RATINGS SYMBOL -005G -01G -015G -02G -03G -04G -05G -06G MAXIMUM RECURRENT PEAK REVERSE VOLTAGE VRRM 50 100 150 200 300 400 500 600 V MAXIMUM RMS VOLTAGE VRMS 35 70 105 140 210 280 350 420 V MAXIMUM DC BLOCKING VOLTAGE VDC 50 100 150 200 300 400 500 600 V MAXIMUM AVERAGE FORWARD RECTIFIED CURRENT IO 5.0 A 0.375”(9.5mm) LEAD LENGTH AT TA=55°C PEAK FORWARD SURGE CURRENT, 8.3ms SINGLE HALF IFSM 150 A SINE-WAVE SUPERIMPOSED ON RATED LOAD TYPICAL JUNCTION CAPACITANCE (NOTE 1) CJ 50 30 PF TYPICAL THERMAL RESISTANCE (NOTE 2) Rθjc 30 ℃/W STORAGE TEMPERATURE RANGE TSTG - 55 TO + 150 ℃ OPERATING TEMPERATURE RANGE TOP - 55 TO + 150 ℃ ELECTRICAL CHARACTERISTICS (AT TA =25°C UNLESS OTHERWISE NOTED) CHARACTERISTICS SYMBOL SF50 -005G SF50 SF50 -01G -015G 0.95 SF50 -02G SF50 SF50 -03G -04G 1.25 SF50 SF50 -05G -06G 1.85 UNITS MAXIMUM FORWARD VOLTAGE AT IO DC VF MAXIMUM REVERSE CURRENT AT 25℃ IR 10 μA MAXIMUM REVERSE CURRENT AT 100℃ IR 100 μA TRR 35 nS MAXIMUM REVERSE RECOVERY TIME (NOTE 3) NOTE: 1. MEASURED AT 1 MHZ AND APPLIED REVERSE VOLTAGE 0F 4.0 VOLTS 2. BOTH LEADS ATTACHED TO HEAT SINK 30×30×1t(mm) COPPER PLATE AT LEAD LENGTH 5mm 3. REVERSE RECOVERY TEST CONDITIONS: IF=0.5A, IR=1.0A, IRR=0.25A SF50-005G THRU SF50-06G Page: 1 V RATINGS AND CHARACTERISTIC CURVE SF50-005G THRU SF50-06G FIG. 1-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC 50Ω NO INDUCTIVE 100Ω NO INDUCTIVE FIG. 2-TYPICAL FORWARD CURRENT DERATING CURVE Trr (-) D.U.T. +0.5A (+) 25 Vdc (approx) 1Ω NON INDUCTIVE (-) OSCILLOSCOPE ( NOTE 1 ) (+) 6.0 AVERAGE FORWARD CURRENT (A) PULSE GENERATOR ( NOTE 2 ) 0 -0.25A NOTE: 1. RISE TIME=7ns MAX. INPUT IMPEDANCE=1 MOhms 22PF 2. RISE TIME =10ns MAX. SOURCE IMPEDANCE=50 OHMS -1.0A INSTANTANEOUS FORWARD CURRENT (A) INSTANTANEOUS REVERSE CURRENT (uA) 100 10 TJ=25oC 1.0 0.1 60 80 100 2.0 1.0 Single Phase Half Wave 60 Hz Resistive or Inductive Load 0 25 50 75 100 125 150 175 AMBIENT TEMPERATURE (oC) FIG. 4-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS 10.0 40 3.0 SET TIME BASE FOR 10/20 ns/cm 1000 20 4.0 1cm FIG. 3-TYPICAL REVERSE CHARACTERISTICS 0 5.0 120 140 SF50-005G~50-02G 1.0 0.1 SF50-03G~50-04G .01 TJ=25oC Pulse Width=300us 1% Duty Cycle .001 .4 .6 .8 1.0 1.2 1.4 1.6 1.8 2.0 INSTANTANEOUS FORWARD VOLTAGE (V) PERCENT OF RATED PEAK REVERSE VOLTAGE (%) FIG. 5-MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT FIG. 6-TYPICAL JUNCTION CAPACITANCE 200 JUNCTION CAPACITANCE (pF) PEAK FORWARD SURGE CURRENT (A) 175 8.3 ms Single Half Sine Wave (JEDEC Method) 150 125 100 75 50 100 60 40 20 6 0 1 5 10 20 50 NUMBER OF CYCLES AT 60HZ SF50-005G THRU SF50-06G 100 TJ=25oC 4 2 2 SF50-005G~50-02G 10 25 1 SF50-03G~50-06G .1 .2 .4 1.0 2 4 10 20 REVERSE VOLTAGE, (V) 40 100 Page: 2