Cable Lug 32/35 mm DIN-Rail Terminals SAKG 28 I SAKG 28 II 0170020000 0170320000 – 28/70/63.5 (1.1/2.76/2.5) 15 (.59) – 28/70/53 (1.1/2.76/2.09) – 600 V / 95 A / #2 AWG 600 V / 110 A / #6…1 AWG 1000 VAC / 110 A / 35 mm2 600 V / 115 A / #2 AWG 600 V / 135 A / #8…2 AWG 1000 VAC / 110 A / 35 mm2 22.6 (200.0) 6 Type EP 1 (2) EP 1 (2) Part No. 0205100000 0205200000 22.6 (200.0) 6 Type EP 1 (2) EP 1 (2) Part No. 0205100000 0205200000 TW 1 (2) TW 1 (2) 0151400000 0164600000 TW 1 (2) TW 1 (2) 0151400000 0164600000 QL 2 QL 3 QL 4 0193900000 0407600000 0407700000 QL 2 QL 3 QL 4 0193900000 0407600000 0407700000 AH 28 0326660000 AH 28 0326660000 Feed Through The Weidmuller SAKG range offers the following connection variations: • Clamping yoke connection, Version III. The stripped conductor can be connected without further preparation. • Lug connection, Version II. Two types of screw connection are provided here. a) Screw set with lock nut b) with thread in the busbar • Clamping yoke/lug connection as a combination, Version I. Available Options Version KrG Dimensions Width / Length / Height mm (in.) with TS 35 x 7.5 with TS 32 Insulation stripping length mm (in.) Technical Data Rated voltage / rated current / wire size UL CSA VDE Version I Version II Torque Nm (lb. in.) Clamping screw M End Plate, Hard Paper (thickness mm) For Tropic-proof without thread Version II G For Tropic-proof Version III with thread Partition, Hard Paper (thickness mm) Cables with cable lugs are connected to Version I SAKG terminals and SS stud terminals. Tropic-proof Fitting instructions for SAKG terminals When tightening the clamping screw, it is recommended that the conductor be held against the tightening direction in order to avoid any deformation of the mounting rail and to keep the terminal foot free of torsional forces. Jumpers Note: Final number in model indicates no. of poles (e.g. QL 2 = 2 poles). For additional information, see Accessories section. QL Cover Cover In order to ensure shock protection following connection of the conductors, Type AH hoods can be snapped onto the terminal. Marking Tags Print Note: Part numbers shown are for a single Consecutive horizontal card of pre-printed tags numbered 1-50. For additional information, see Accessories section. Consecutive vertical DEK 5/5 0473460001 DEK 5/5 0473460001 DEK 5/5 0473560001 DEK 5/5 0473560001 See Accessories section for mounting rails, end brackets, test taps, additional marking material and accessories. 150