UG30APT THRU UG30DPT ULTRAFAST EFFICIENT PLASTIC RECTIFIER Reverse Voltage - 50 to 200 Volts Forward Current - 30.0 Amperes TO-247AD FEATURES 0.645 (16.4) 0.625 (15.9) 0.203 (5.16) 0.193 (4.90) 0.245 (6.2) 0.225 (5.7) 0.078 REF (1.98) 0.323 (8.2) 0.313 (7.9) 10o 30o 0.170 (4.3) 10o TYP. BOTH SIDES 0.840 (21.3) 0.820 (20.8) 0.142 (3.6) 0.138 (3.5) 1 2 3 0.086 (2.18) 0.076 (1.93) 1o REF. BOTH SIDES 0.118 (3.0) 0.127 (3.22) 0.108 (2.7) 0.117 (2.97) 0.160 (4.1) 0.140 (3.5) ♦ Plastic package has Underwriters Laboratory Flammability Classification 94V-0 ♦ Ideally suited for use in very high frequency switching power supplies, inverters and as a free wheeling diodes ♦ Ultrafast, 15 nanosecond typical recovery time ♦ Low leakage current ♦ Glass passivated chip junctions ♦ Soft recovery characteristics ♦ Excellent high temperature switching ♦ High temperature soldering guaranteed: 250°C, 0.16” (4.06mm) from case for 10 seconds 0.795 (20.2) 0.775 (19.6) MECHANICAL DATA 0.048 (1.22) 0.225 (5.7) 0.205 (5.2) 0.030 (0.76) 0.044 (1.12) 0.020 (0.51) PIN 1 PIN 2 PIN 3 CASE Dimensions in inches and (millimeters) Case: JEDEC TO-247AD molded plastic body over passivated chips Terminals: Plated leads solderable per MIL-STD-750, Method 2026 Polarity: As marked Mounting Position: Any Weight: 2.2 ounces, 6.3 grams MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25°C ambient temperature unless otherwise specified. SYMBOLS UG30APT UG30BPT UG30CPT UG30DPT UNITS Maximum repetitive peak reverse voltage VRRM 50 100 150 200 Volts Maximum RMS voltage VRMS 35 70 105 140 Volts Maximum DC blocking voltage VDC 50 100 150 200 Volts Maximum average forward rectified current at TC=120°C I(AV) 30.0 Amps Peak forward surge current 8.3 ms single half sine-wave superimposed on rated load (JEDEC Method) at TC=120°C IFSM 300.0 Amps Maximum instantaneous forward voltage per leg at 15A 30A 10A TJ=100°C Maximum DC reverse current at rated DC blocking voltage per leg Maximum reverse recovery time (NOTE 1) Maximum reverse recovery time (NOTE 2) Maximum recovered stored charge (NOTE 2) Typical junction capacitance (NOTE 3) Typical thermal resistance (NOTE 4) Operating and storage temperature range VF TA =25°C TA =100°C Volts IR 5.0 800.0 µA trr 20.0 ns TJ= 25°C TJ=100°C trr 35.0 50.0 ns TJ=25°C TJ=100°C Qrr 22.0 50.0 nC CJ 70.0 pF RΘJC 2.0 °C/W TJ, TSTG -65 to +150 °C NOTES: (1) Reverse recovery test conditions: IF=0.5A, IR =1.0A, Irr=0.25A (2) trr and Qrr measured at: IF=15A VR=30V, di/dt=50 A/µs, IRR=10% IRM for measurement of trr (3) Measured at 1.0 MHZ and applied reverse voltage of 4.0 Volts (4) Thermal resistance from junction to case per leg mounted on heatsink 4/98 1.0 1.15 0.85 RATINGS AND CHARACTERISTIC CURVES UG30APT THRU UG30DPT FIG. 2 - MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT PER LEG FIG. 1 - FORWARD CURRENT DERATING CURVE 1,000 30 24 18 12 6 0 0 25 50 75 100 10 100 125 150 175 1 CASE TEMPERATURE, °C 10 TJ=25°C PULSE WIDTH=300µs 1% DUTY CYCLE 0.1 0.01 0.4 0.6 0.8 1.0 1.2 1.4 1.6 INSTANTANEOUS REVERSE LEAKAGE CURRENT, MICROAMPERES 100 1 1,000 10 TJ=25°C 1 0.1 0.01 0 20 40 60 80 100 PERCENT OF RATED PEAK REVERSE VOLTAGE, % 100 60 di/dt=150 A/µs di/dt=20 A/µs IF=15A VR=30V di/dt=100 A/µs di/dt=50 A/µs di/dt=100 A/µs 40 di/dt=150 A/µs 30 di/dt=50 A/µs 20 di/dt=20 A/µs 10 0 TJ=100°C 100 FIG. 6 - TYPICAL JUNCTION CAPACITANCE PER LEG trr Qrr 25 50 75 100 125 150 175 JUNCTION TEMPERATURE, °C JUNCTION CAPACITANCE, pF RECOVERED STORED CHARGE/REVERSE RECOVERY TIME, nC/ns FIG. 5 - REVERSE SWITCHING CHARACTERISTICS PER LEG 0 100 FIG. 4 - TYPICAL REVERSE CHARACTERISTICS PER LEG INSTANTANEOUS FORWARD VOLTAGE, VOLTS 50 10 NUMBER OF CYCLES AT 60 HZ FIG. 3 - TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS PER LEG INSTANTANEOUS FORWARD CURRENT, AMPERES TC=120°C 8.3ms SINGLE HALF SINE-WAVE (JEDEC Method) RESISTIVE OR INDUCTIVE LOAD PEAK FORWARD SURGE CURRENT, AMPERES AVERAGE FORWARD CURRENT, AMPERES 36 TJ=125°C f=1.0 MHz Vsig=50mVp-p 10 1 0.1 1 10 REVERSE VOLTAGE, VOLTS 100