2 x 5mm Rectangular ® Optopipe® Optical Light Pipe, Single DIFFUSED FRONT SURF ACE 3.30 [.130] 2.00 [.080] 515-1054 MicroLED SMT LEDs for use with 515-1054 FRONT PANEL 5.08 [.200] PART NO. 11.43 [.450] 8.89 [.350] 2.29 [.090] 2.79 [.11] 3.18 [.125] 4.32 [.170] 7.62 [.300] 1.65 [.065] 8.89 [.350] Ø2.01 [.079] 2 PLCS 7.62±.08 [.300±.003] DIRECTION OF LIGHT 5.00 [.197] 1-21 1-23 1-30 1-31 LED alternatives may not produce optimum light output 2.21 [.087] 4.45 [.175] 2.41 [.095] TYP PAGE # 1.14 [.045] FRONTPANELNOTSHOWN IN THIS VIEW 1.65 [.065] Recommeded 597-3xx1-2xx 597-77x1-2xx Alternatives 597-3xx1-5xx 597-77x1-5xx NOTE: designed for post-reflow PC board insertion. Solder Pad/Holes layout shown is for single color LEDs listed under “Recommended” category Contact factory for other layouts Ø .076±.002 TYP; 2 PLCS Dimensions in mm [inches] RECOMMENDED SOLDER AD/HOLE P LA YOUT Features • • • • • • Compatible with Dialight’s 515-1051 High transmissivity polycarbonate material UL94V-0 compliance ESD protection (circuit isolation from front panel) Wide viewing angle Secures to PCB by press-fit LED Data Operating/Storage Temperature For absolute maximum ratings and other electrical and optical data on the recommended LEDs, refer to LED data sheets. –30°C to +100°C Dialight Optopipe Light Pipe Description This Optopipe® functions as a through-the-case indicator with the appearance of a single 2 x 5mm rectangular LED. It can utilize either a single or multi-color SMT LED, and can be used to form longer arrays with the 515-1051 light pipe. It is held to the PCB by 2 press-fit pins. The light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index. Dialight can provide custom Optopipe® solutions for your applications. Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: (732) 919-3119 • FAX: (732) 751-5778 •www.dialight.com