3mm Round ® OptopipeTM Optical Light Pipe, 3 Array 515-1069 16.26 [.640] 6.35 [.250] 3.61 [.142] 13.06 [.514] 3.18 [.125] 3.56 [Ø.140] 2.39 [.094] 3.00 [.118] 6.35 [.250] 3.56 [.140] NOTE: C.L. of LED 2.00 [.079] TYP; (2) PLACES 1.70 [.067] NOTE: designed for post-reflow PC board insertion. 1.45 [.057] 1.52 [.060] 4.19 [.165] Recommended MicroLED SMT LEDs for use with 515-1069 PART NO. COLOR PAGE # 597-3111-4xx 597-3201-4xx 597-3311-4xx 597-3401-4xx AlGaAs Red Orange Green Yellow 1-28 1-28 1-28 1-28 1.35 [.053] DIRECTION OF LIGHT 1.93 [.076 ±.002] 2.34 [.092] 8.69 [.342] 4.01 [.158] Dimensions in mm [inches] RECOMMENDED PIN HOLES AND SOLDER PAD LAYOUT FOR SUGGESTED MicroLED LEDs COMPONENT SIDE OF PRINTED CIRCUIT BOARD Features LED Data • Complements Dialight’s 515-1020 and 515-1071 Optopipe Light Pipes For absolute maximum ratings and other electrical and optical data on the recommended LEDs, refer to LED data sheets. • High transmissivity polycarbonate material • UL94V-0 compliance • ESD protection (circuit isolation from front panel) Operating/Storage Temperature • Wide viewing angle –30°C to +100°C • Arrays reduce insertion costs • Secures to PCB by press-fit Dialight Optopipe Light Pipe Description This light pipe’s circular light emitting surfaces appear bright and uniform in intensity. It is reliably held in place by 2 press-fit pins located between the 3 light pipe elements. This Optopipe™ functions as a through-the-case indicator with a textured finish on the 3 light emitting surface that increases its viewing angle. The recommended light sources are Dialight's 597 Series PLCC-2 or PLCC-4 Type SMT LEDs. The LEDs are mounted in a straight line on an 0.250" pitch. The light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index. Dialight can provide custom Optopipe™ solutions for your applications. 2-36 Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: (732) 919-3119 • FAX: (732) 751-5778 •www.dialight.com