NEW 1.63mm Round ® OptopipeTM Optical Light Pipe, Panel Mount 1.52 [.006] 45° R .05 [.002} MAX 60° REF (TYP) Ø .84 [Ø .033] DIFFUSED FRONT SURFACE 1.22 [.048] 2.16 [.085] Ø 1.63 [Ø .064] 4.14 [.163] Ø .94 [Ø .037] (MAJOR DIA) .51 [.020] MAX 515-1016 Alternative MicroLED SMT LEDs for use with 515-1016 PART NO. PAGE # 597-2x01-2xx 597-2xx1-4xx 1-25 1-29 LED alternatives may not produce optimum light output DIRECTION OF LIGHT Dimensions in mm [inches] TOP SURFACE OF LED RECOMMENDED PLACEMENT OF LED Features • • • • • High transmissivity polycarbonate material UL94V-0 compliance ESD protection (circuit isolation from front panel) Wide viewing angle Secures to panel by press-fit LED Data Operating/Storage Temperature For absolute maximum ratings and other electrical and optical data on the recommended LEDs, refer to LED data sheets. –30°C to +100°C Dialight Optopipe Light Pipe Description This Optopipe’s™ larger light emitting surface appears bright. It is reliably held in the panel by 3 press-fit splines. This Optopipe™ functions as a through-the-case indicator with a textured finish on the light-emitting surface that increases its viewing angle. The light sources can be one of Dialight’s 597 Series SMT LEDs. The light source’s emitting surface should be located no more than 0.020" or 0.5mm from the Optopipe™. The light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index. Dialight can provide custom Optopipe™ solutions for your applications. 2-12 Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: (732) 919-3119 • FAX: (732) 751-5778 •www.dialight.com