Oscilent Corporation RF SAW Filter | 802-RF2441.8M-A Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 802-RF2441.8M-A 3.0 x 3.0 SMD Bluetooth July 18, 2007 . TYPE : Bluetooth, RF SAW Filter PART NUMBER : 802-RF2441.8M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 2441.8 - MHz 2400.0 ~ 2483.5 MHz - 2.5 5.0 dB D.C. ~ 1700.0 MHz 20 29 - 1700.0 ~ 2200.0 MHz 25 30 - 2700.0 ~ 3100.0MHz 30 40 - 3100.0 ~ 4000.0 MHz 20 29 - 4000.0 ~ 5000.0 MHz 10 20 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm VSWR 2400.0 ~ 2483.5 MHz - 1.7 2.6 - Amplitude Ripple 2400.0 ~ 2483.5 MHz - 1.2 3.0 dBp-p Maximum DC Voltage - - - 0 V Maximum Input Power - - - 10 dBm Operating Temperature - -40 - +85 ºC Center Frequency (Fo) Maximum Insertion Loss Attenuation: dB * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B Out C Ground D Ground E In F Ground Oscilent Corporation RF SAW Filter | 802-RF2441.8M-A Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Page 2 of 3 Oscilent Corporation RF SAW Filter | 802-RF2441.8M-A Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF2441.8M-A