Oscilent Corporation RF SAW Filter | 802-RF463.5M-A Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 802-RF463.5M-A 3.0 x 3.0 SMD CDMA450 Jan. 01, 2007 . TYPE : CDMA450, RF-Rx SAW Filter PART NUMBER : 802-RF463.5M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Stop Band Attenuation: Condition Minimum Typical Maximum Units - - 463.5 - MHz 461.3~ 465.8 MHz - 2.7 4.5 dB 0.3~ 451.3 MHz 40 50 - 451.3~ 455.8 MHz 35 48 - 485.0~ 507.5MHz 40 50 - 507.5~ 1200.0 MHz 35 47 - dB 1200.0~ 2000.0 MHz 30 40 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm 461.3~ 465.8 MHz - 1.5 2.0 - VSWR Maximum Input Power - - - 27 dBm Operating Temperature - -30 - +80 ºC * No Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE Source/ Load Impedance = 50 ohms A Ground B Out C Ground D Ground E In F Ground Oscilent Corporation RF SAW Filter | 802-RF463.5M-A Page 2 of 2 FREQUENCY RESPONSE VSWR SMITH CHART Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF463.5M-A