Oscilent Corporation RF SAW Filter | 802-RF1802.5M-A Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 802-RF1802.5M-A 3.0 x 3.0 SMD Wireless Jan. 01, 2007 . TYPE : Wireless, RF SAW Filter PART NUMBER : 802-RF1802.5M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Insertion Loss Stop Band Attenuation: Amplitude Ripple Source Impedence (single ended)* Condition Minimum Typical Maximum Units - - 1802.5 - MHz 1800.0~ 1805.0 MHz - 2.6 3.5 dB Fo-70.0 MHz 30 40 - Fo+70.0 MHz 30 45 - 1800.0~ 1805.0 MHz - 0.3 1.5 dBp-p - - 50 - ohm ohm dB - - 50 - 1800.0~ 1805.0 MHz - 2.1 2.5 - Maximum DC Voltage - - - 0 V Maximum Input Power - - - 5 dBm Operating Temperature - -30 - +85 ºC Load Impendance (single ended)* VSWR * No Matching Network (Ref. Testing Environment Circcuit as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B Out C Ground D Ground E In F Ground Oscilent Corporation RF SAW Filter | 802-RF1802.5M-A Load/ Source Impedance = 50ohms FREQUENCY RESPONSE VSWR SMITH CHART Page 2 of 3 Oscilent Corporation RF SAW Filter | 802-RF1802.5M-A Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF1802.5M-A