Oscilent Corporation IF SAW Filter | 813-SL95.0M-15 Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 813-SL95.0M-15 13.3 x 6.5 SMD IF SAW Filter Jan. 01, 2007 TYPE : IF SAW Filter PART NUMBER : 813-SL95.0M-15 OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units Center Frequency (Fo) - 95.0 - MHz Insertion Loss at Fo - 12.5 15.0 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Temperature Coefficient - -94 - ppm/C Amplitude Ripple - 0.50 1.0 dBp-p 1.0dB Bandwidth - 14.0 - MHz 3.0dB Bandwidth 14.2 14.5 - MHz 5.0dB Bandwidth - 14.9 15.2 MHz 30.0dB Bandwidth - 16.9 17.5 MHz - 17.2 18.5 MHz Relative Attenuation: 40 48 - dB Group Delay Variation - 50 120 ns Absolute Delay at Fo - 1.15 - us Ambient Temperature - 25 - C 40.0dB Bandwidth *With Matching Network (Ref. Testing Environment Circuit as Shown Below). Those impedances could be modified with different impedance values and/or structures, if necessary PACKAGE OUTLINE (mm) PIN DESCRIPTIONS: IN - 11, OUT - 5, GROUND - 1,2,3,4,6,7,8,9,10,12 TEST CIRCUIT Oscilent Corporation IF SAW Filter | 813-SL95.0M-15 Page 2 of 2 TEST FIXTURE AND VALUES/SOURCE AND LOAD IMPEDANCE 50 ohm INPUT: L1: 120 nH; C1: 51 pF OUTPUT: L2: 33 nH FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 813-SL95.0M-15