Oscilent Corporation IF SAW Filter | 821-IF140.0M-D Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 821-IF140.0M-D 20.0 x 9.8mm SMD IF SAW Filter Mar. 10, 2007 . TYPE : 140.0MHz IF SAW Filter PART NUMBER : 821-IF140.0M-D .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units MHz 139.9 140.0 140.1 Insertion Loss - 22.0 25.0 dB Source Impedance (single ended)* - 50 - ohm Center Frequency - 50 - ohm Bandwidth -1.0 dB 6.8 7.1 - MHz Bandwidth -3.0 dB 7.3 7.6 - MHz Bandwidth -40.0 dB - 9.5 10.0 MHz Amplitude Ripple - 0.7 1.0 dBp-p Lower Sidelobe - 52 25.0 dB Upper Sidelobe Load Impedance (single ended)* - 52 25.0 dB Group Delay Variation - 50 100 nsec Absolute Delay @ Fo - 2.84 - µsec Temperature Coefficient - -23 - ppm/°C *With Matching Network(ref. Testing Enviornment Circut as shown below). Those impedances could be modified with different impedance values and/or structures, if necessary. . PACKAGE OUTLINE (mm) PIN Descriptions: IN-10, OUT-5, GROUND-1,2,3,4,6,7,8,9 )TEST FIXTURE Oscilent Corporation IF SAW Filter | 821-IF140.0M-D Page 2 of 2 Frequency Responce Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 821-IF140.0M-D