Oscilent Corporation IF SAW Filter | 821-IF65.0M-H Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 821-IF65.0M-H 20 x9.8 SMD 65.0 MHz IF SAW Filter Jan. 01 2007 . TYPE : 65.0 MHz IF SAW Filter PART NUMBER : 821-IF65.0M-H .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units Center Frequency (Fo) - 65.0 - MHz Insertion Loss - 18.5 20.5 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Temperature Coefficient - -72 - ppm/C Amplitude Ripple within fo+/-9.75Mhz - 0.65 1.0 dBp-p 1dB Bandwidth 9.8 10.00 - MHz 3dB Bandwidth 10.3 10.52 - MHz 40dB Bandwidth - 12.63 12.8 MHz 50dB Bandwidth - 12.82 13.0 dB Attenuation Rejection 50 55 - dB Absolute Delay at Fo - 1.67 - µsec Group Delay Variation - 45 100 nsec *With Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedance values and/or structures, if necessary. ** Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE L1 = 68nH L2 = 120nH C1 = 24pF - Source/Load Impedance = 50 ohms Pin Descriptions: IN-10, OUT-5, GROUND- 1,2,3,4,6,7,8,9 FREQUENCY RESPONSE Oscilent Corporation IF SAW Filter | 821-IF65.0M-H Page 2 of 2 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 821-IF65.0M-H