Oscilent Corporation IF SAW Filter | 827-IF120.0M-A Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 827-IF120.0M-A 27.2 x 12.6 Thru Hole Base Station & Repeater May 30 2003 . TYPE : 120.0 MHz Bandpass Filter 0.9 MHz Bandwidth PART NUMBER : 827-IF120.0M-A . Horizontal : 0.4 MHz/Div Veritical : 10 dB/Div Horizontal : 0.2 MHz/Div Veritical : 1 dB/Div Veritical : 100 ns/Div . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 119.96 120.0 120.04 MHz - 18.7 20.0 dB 1.5dB Bandwidth 0.9 0.99 - MHz 35dB Bandwidth - 1.6 1.73 MHz 50dB Bandwidth - 1.74 1.8 MHz Passband Ripple - 0.46 .8 dB Group Delay Variation - 310 400 nsec Center Frequency Insertion Loss - 3.45 - µsec Ultimate Rejection 50 55 - dB Substrate Material - Qz - - Ambient Temperature - 25 - °C Phase Linearity - 4.85 8 deg Absolute Delay * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE http://www.oscilent.com/spec_pages/if_sawfilter/if_827_if120_0a.htm 12/28/2005 Oscilent Corporation IF SAW Filter | 827-IF120.0M-A Page 2 of 2 L1 = 56nH C1 = 62pF L2 = 47nH C2 = 68pF Source/Load Impedance = 50 ohms Part No.: 827-IF120.0M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_827_if120_0a.htm 12/28/2005